Tennsco 1340397 Assembly Instructions/Parts Manual

READ INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING
TO ASSEMBLE YOUR Tennsco ELECTRONIC WORKBENCH.
DESCRIPTION
e lectronic wo rkbenches a re des igned for
Tennsco
electronic ass embly, tes ting, pr oduct de velopment an d
other u ses w here a ccess to multiple power
important. The workbench can use either 30" x 60", 30" x
72" wood tops or 36" x 72" steel tops (see below). Workbench
legs and frames ar e box for med for s trength and r igidity.
Frame front panel has knockouts for four duplex receptacles
as well as a switch and circuit breakers (order optional wiring
kit separately). Removable cover behind r eceptacle panel
facilitates wiring and prevents contact with rear terminals.
tops are available in a choice of two widths and
Tennsco
two de pths a nd ar e pr e-drilled for mounting to var ious
workbench bases.
Steel Benchtops ( S) ar e cons tructed of smo oth st eel
surfaces, reinforced with channels at each end. There are
no exposed s harp edges or corners. A s teel s tringer is
included to provide extra rigidity.
Hard Maple Laminate Benchtops (W ) a re 1
laminated sol i d hard maple with a smo oth oi l -seal natural fi n ish.
Plastic Laminate Benchtops (P) are 1
linen, m aintenance-free, h igh pr essure non- conductive
plastic l aminate o ver a com pressed w ood core w ith a
phenolic backer sheet.
Compressed Wood Benchtops (C) ar e 1
constructed of tempered hardboard top and bottom s urfaces
laminated to a high density
smooth, sealed finish gives a durable, non-porous surface.
Available options ar e listed in the r eplacement par ts list
included in these instructions.
ASSEMBLY INSTRUCTIONS & PARTS MANUAL #1340397
ELECTRONIC WORKBENCH
Tennsco Corp., Dickson, TN 37056-1888 * (615) 446-8000
RETAIN INSTRUCTIONS FOR FUTURE REFERENCE!
outlets is
3
⁄
4
5
" thick with gr ey
⁄
8
3
" thick and
⁄
4
compr essed wood cor e. A
Overall Dimensions
All 3072 models .......................... 72"w x 30"d x 33
All 3672 models .......................... 72"w x 36"d x 33
Basic Construction
Steel Top
Top ..................................................12 gauge steel
Reinforcing Channels ......................14 gauge steel
Hard Maple Laminate Top
Top ..............................................Laminated Maple
Compressed Wood Top
Top ........ Hardboard with Compressed Wood Core
Plastic Laminate Top
Top ..............Laminated High Pressure Plastic with
Panel Legs .............................................16 gauge steel
Stringer ..................................................14 gauge steel
Wireway Cover ......................................20 gauge steel
" t hick
Receptacle Panel...................................16 gauge steel
Back Panel.............................................16 gauge steel
Options Available:
Side and back rails
Standard and electronic riser
GENERAL SAFETY INFORMATION
Some parts may hav e sharp edges. CA RE must be taken
when handling v arious pieces to avoid injury. F or safety,
wear a pair of work gloves when assembling or performing
any maintenance on workbench.
SPECIFICATIONS
Compressed Wood Core
Lower Shelf
Stackable Drawer
1
"h
⁄
2
1
"h
⁄
2