Tennsco WB 3072 Series Assembly Instructions/Parts Manual

READ INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING
TO ASSEMBLE YOUR Tennsco INDUSTRIAL WORKBENCH.
DESCRIPTION
Rugged construction makes these
ideally suited for factories, shops, garages, labs, etc.
Workbenches are shipped unassembled with tops and legs
in separate cartons.
The fixed height, flared legs have all-welded steel
construction with punched holes for attaching stringer, and
lower shelf flanged feet have holes for securing to floor. Legs
are 32" high and 30" or 36" deep.
Duplex knock-outs are punched in each leg to receive a steel
city electrical box, model #CDOW (2.5" X 2" X 3").
Tennsco
tops are available in a choice of two widths and
two depths and are pre-drilled for mounting to various
workbench bases. A steel stringer is included to provide
extra rigidity.
Steel Benchtops (S) are constructed of smooth steel
surfaces, reinforced with channels at each end. There are
no exposed sharp edges or corners.
Hard Maple Laminate Benchtops (W) are 1
laminated solid hard maple with a smooth oil-seal natural finish.
Plastic Laminate Benchtops (P) are 1
linen, maintenance-free, high pressure non-conductive
plastic laminate over a compressed wood core with a
phenolic backer sheet.
Compressed Wood Benchtops (C) are 1
constructed of tempered hardboard top and bottom surfaces
laminated to a high density compressed wood core. A
smooth, sealed finish gives a durable, non-porous surface.
Available options are listed in the replacement parts list
included in these instructions.
ASSEMBLY INSTRUCTIONS & PARTS MANUAL #1290605
INDUSTRIAL WORKBENCH
Tennsco Corp., Dickson, TN 37056-1888 * (615) 446-8000
RETAIN INSTRUCTIONS FOR FUTURE REFERENCE!
Tennsco
workbenches
⁄
3
4
⁄
5
" thick with grey
8
⁄
3
" thick and
4
Overall Dimensions
All 3060 models .......................... 60"w x 30"d x 33
All 3072 models .......................... 72"d x 30"w x 33
All 3660 models .......................... 60"d x 36"w x 33
All 3672 models .......................... 72"d x 36"w x 33
Basic Construction
Steel Top
Top ................................................. 12 gauge steel
Reinforcing Channels ..................... 14 gauge steel
Hard Maple Laminate Top
Top ..............................................Laminated Maple
Compressed Wood Top
Top ........ Hardboard with Compressed Wood Core
Plastic Laminate Top
Top ..............Laminated High Pressure Plastic with
Legs ...................................................... 14 gauge steel
" thick
Upper and lower leg crossmembers ..... 13 gauge steel
Stringer ................................................. 14 gauge steel
Options Available:
Side and back rails
Standard and electronic riser
GENERAL SAFETY INFORMATION
Some parts may have sharp edges. CARE must be taken
when handling various pieces to avoid injury. For safety,
wear a pair of work gloves when assembling or performing
any maintenance on workbench.
SPECIFICATIONS
Compressed Wood Core
Lower Shelf
Stackable Drawer
⁄
1
"h
2
⁄
1
"h
2
⁄
1
"h
2
⁄
1
"h
2