Advertisement
LINX 140 and LINX 140 T
Residential Drinking Water Systems (100-120V) with LINX Technology and Dial-a-Taste Mineral Level Control (Rev
B; February 14, 2011; Software 20.063). Owners manual. Pionetics 05-3019-B
Boyett's Family Rayne Water Conditioning is proud to be a dealer of the LINX 140 and LINX 140 T Residential
Drinking Water Systems (100-120V) with LINX Technology and Dial-a-Taste Mineral Level Control. If you need any
parts, filters or service – just give us a call (480) 969-7251.
Dial-A-Taste® Mineral Level Control
The mineral level of the product water can be changed by turning the Dial-a-Taste control at the front of the unit.
Turning the dial clockwise increases mineral content. As the dial is turned, the blue and red LEDs will light-up for
several seconds to indicate the mineral level selected. None of the four LEDs will light-up when the dial is set to the
full clockwise position indicating that the highest mineral content is selected (-70% TDS reduction). One LED means
the second highest mineral level, two LEDs mean the middle level, three LEDs mean the second lowest level, and all
four LEDs mean the lowest mineral level is selected (>85% TDS reduction, full counter-clockwise dial position). After
the dial has been set, the LEDs indicating mineral level will turn off and resume their normal display. For the LINX
140 system, approximately one quart of water must be drawn before a change in mineral level is fully realized. For
the LINX 140T system, the tank must be emptied and refilled to observe the change.
When treating water comprising regulated contaminants, the Dial-a-Taste control should be set fully counter-
clockwise to maximize reduction of the regulated contaminant.
Section 5. Maintenance
LINX 100 TDS Cartridges, LINX 100 Sediment Filters, and LINX 100 or 110 Carbon Filters The LINX 140 and LINX
140T systems include three types of replaceable components:
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Pionetics LINX 140
Summary of Contents for Pionetics LINX 140
- Page 1 B; February 14, 2011; Software 20.063). Owners manual. Pionetics 05-3019-B Boyett’s Family Rayne Water Conditioning is proud to be a dealer of the LINX 140 and LINX 140 T Residential Drinking Water Systems (100-120V) with LINX Technology and Dial-a-Taste Mineral Level Control. If you need any parts, filters or service –...
- Page 2 Two L1NX 100 TDS cartridges One LINX 100 Sediment filter One LINX 100 or 110 Carbon filter (GAC). The indicator lights let you know it is time to call for service (see Indicator Status Table in the previous section). The LINX 100 Sediment and L1X 100 or 110 Carbon filters need replacement at 650 gallons, while the LNX 100 TDS cartridges require,replacement at 1300 gallons.
- Page 3 (Blue indicator light A or C flashing) (LINX 140 system only) Low Flow Rate • Feed water pressure near low end of specified range (<20 psi). Remedy —Call your Authorized Dealer to install a booster pump (L1NX 140 system only) ...
- Page 4 Objectionable Taste or Odor • LINX 100 Carbon filter missing or exhausted. Remedy – Call the Authorized Dealer to replace carbon filter • Poor TDS reduction Dial-a-Taste knob set to high mineral level (rotated clockwise). Missing or damaged bottom LINX 100 TDS cartridge 0-ring ...
- Page 5 LINX 100 TDS Cartridge bottom 0-ring 28-00025-A LINIX cell lid drivers 19-000001 Front Enclosure 07-000008 Front Lid Cover 07-000012 Back Lid Cover 07-000013 Drain Valve Body, Left (from rear) 28-000309 Drain Valve Body, Right (from rear) 28-000310 LED PCB 19-000610 Power cord 19-000006...
Need help?
Do you have a question about the LINX 140 and is the answer not in the manual?
Questions and answers