Supplier's Declaration Of Conformity - NEC DS1-TM01 User Manual

Please install the monitor in accordance with the following information.
Improper installation of the monitor may result in damage to the monitor, an electric shock or fire.
Do not install the monitor in the locations below:
- Near a radiator, other heat sources, or in direct sunshine.
- Continual vibration areas.
- Humid, dusty, steamy or oily areas.
- Outdoors
- High-temperature environment where humidity changes rapidly and condensation is likely to
occur.
Do not mount this product face up, face down, or upside down for an extended period of time
as it may cause permanent damage to the screen.
To ensure the monitorʼs reliability, please clean the ventilation holes at the rear side of the cabinet
at least once a year to remove dirt and dust.

Supplier's Declaration of Conformity

FCC SDoC
This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions. (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
U.S. Responsible Party: NEC Display Solutions of America, Inc.
Address:
Tel. No.:
Type of Product:
Equipment Classification: Class B Peripheral
Model:
FCC Information
The Federal Communications Commission does not allow any modifications or changes to the unit EXCEPT
those specified by NEC Display Solutions of America, Inc. in this manual. Failure to comply with this
government regulation could void your right to operate this equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy, and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult your dealer or an experienced radio/TV technician for help.
3250 Lacey Rd, Ste 500
Downers Grove, IL 60515
(630)-467-3000
Tuner Module
DS1-TM01
English-3
CAUTION