Advertisement
5.
Install the Floor Mats
Install the floor mats where they belong. Place the driver's floor mat eyelets over the anchors in the floor, then turn the
knobs clockwise to the lock position.
Under-Hood (Engine Cold)
6.
Check the Battery
To ensure long battery life and that the customer gets a fully charged battery, it must be checked at these times:
•
When the vehicle first arrives at the dealership
•
During the PDI (if done at a later time)
•
At regular intervals (if stored)
•
Just before vehicle delivery
Test the battery with the ED-18 battery tester using S/B 88-023, Battery Testing and Replacement. If the ED-18 does
not show GOOD BATTERY, charge the battery with the GR8 battery diagnostic station.
Write down the GOOD BATTERY 10-digit code in the PDI and Final Delivery Checklist. During the PDI, write down the
code in the "Under Hood - Engine Cold" section. Then, at vehicle delivery, test the battery again, charge if needed, and
write down the new code in the "Final Inspection (At Delivery)" section.
NOTE: Make sure the ED-18 has the latest software installed before using it. See S/B 09-045, ED-18 Battery Tester
Update Information.
Under Vehicle (On Lift)
NOTE: A flat lift may interfere with the side spoiler. Use attachments that help prevent damaging it.
7.
Install the Body Plugs
Install the body plugs as shown.
Page 5 of 9
Advertisement
