Download Print this page

Kobalt KRC 2404-03 Manual page 5

24-volt 4-port charger

Advertisement

Available languages

Available languages

SAFETY INFORMATION
• Do not abuse the cord or charger. Never use the cord to carry the charger. Do not pull the
charger cord to disconnect the plug from a receptacle. Damage to the cord or charger could
occur and create an electric shock hazard. Replace damaged cords immediately.
• Make sure that the cord is located so that it will not be stepped on, tripped over, come in
contact with sharp edges or moving parts, or otherwise subjected to damage or stress. This
will reduce the risk of accidental falls, which could cause injury and damage to the cord,
which could then result in electric shock.
• Keep the cord and charger away from heat to prevent damage to the housing or internal
parts.
• Do not allow gasoline, oils, petroleum-based products, etc. to come in contact with plastic
parts. These materials contain chemicals that can damage, weaken, or destroy plastic.
• An extension cord should not be used unless absolutely necessary. Use of an improper
extension cord could result in a risk of fire and electric shock. If an extension cord must be
used, make sure that:
• The pins on the plug of extension cord are the same number, size and shape as those of the
plug on charger.
• The cord is properly wired and in good electrical condition
• The size is large enough for A/C ampere rating of charger as specified below:
Cord Length (Feet)
Cord Size (AWG)
NOTE: AWG = American Wire Gauge
• Do not operate the charger with a damaged cord or plug, which could cause shorting and
electric shock. If damaged, have the charger repaired or replaced by an authorized service
technician.
• Do not operate the charger if it has received a sharp blow, been dropped, or has otherwise
been damaged in any way. Take it to an authorized service technician for an electrical check
to determine if the charger is in good working order.
• Do not disassemble the charger. Take it to an authorized service technician when service or
repair is required. Incorrect reassembly may result in a risk of electric shock or fire.
• Unplug the charger from the electrical outlet before attempting any maintenance or cleaning
to reduce the risk of electric shock.
• Disconnect charger from the power supply when not in use. This will reduce the risk of
electric shock or damage to the charger if metal items should fall into the opening. It will also
help prevent damage to the charger during a power surge.
• Risk of electric shock. Do not touch the uninsulated portion of output connector or
uninsulated battery terminal.
• Save these instructions. Refer to them frequently and use them to instruct others who may
use this tool. If you loan this tool to someone else, also loan these instructions to them to
prevent misuse of the product and possible injury.
DANGER
• People with electronic devices, such as pacemakers, should consult their physician(s)
before using this product. Operation of electrical equipment in close proximity to a heart
pacemaker could cause interference or failure of the pacemaker.
25 ft.
50 ft.
16
16
5
100 ft.
16

Advertisement

loading

This manual is also suitable for:

1051229