Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Intertec Data Systems HT-ExVENT
Summary of Contents for Intertec Data Systems HT-ExVENT
- Page 1 Operating Instructions Ventilator HT-ExVENT COM734795531Ien-1 • 03/12/2019...
-
Page 2: Table Of Contents
www.intertec.info Table of Content 1 Use ................................... 3 2 Explanation of symbols for warnings and signal words .................. 3 3 Safety information .............................. 3 4 Technical Data ................................ 3 5 Installation................................ 4 6 Connection................................ 5 7 Commissioning............................... 5 8 Troubleshooting .............................. 5 9 Directions for use .............................. -
Page 3: Use
Operating Instructions Ventilator HT-ExVENT NOTICE The HT-ExVENT fan is manufactured according to Dir- ective 2014/34/EU and is used for the aeration and vent- NOTE ilation of housings. It consists of an encapsulated It is essential to pay attention to this safety advice as you shaded pole motor ExVENT in a stainless steel housing,... -
Page 4: Installation
• Cut-out size 190 x 190 mm • Smooth the edges of the mounting cut-out • The HT-ExVENT is placed on the inside of the cut- • The clamping lugs can be perceptibly and audibly clicked into place in all four corners by exerting slight pressure Illustration 2: HT-ExVENT front view blowing in... -
Page 5: Connection
Air flow blowing in sign. Commissioning Illustration 3: HT-ExVENT side view blowing in If the electric motor was installed according to the guidelines specified under section Installation and sec- tion Connection [}Page 5] and it is guaranteed that no foreign bodies can reach the rotating components, then the electric motor can be switched on. -
Page 6: Directions For Use
Operating Instructions Ventilator HT-ExVENT To preserve the operational capability and to prevent un- DANGER planned downtimes of the device, please observe the following measures: Risk of fatal injury from electric current! • Bearing/drive shaft: If contact is made with live components, there is the risk Both must be kept free of contamination, visual in- of fatal injury. -
Page 7: 12 Eu Declaration Of Conformity
Operating Instructions Ventilator HT-ExVENT The local community authorities or specialist waste dis- Please contact your INTERTEC contact person or dir- posal companies can provide information on environ- ectly contact mentally friendly disposal. INTERTEC-Hess GmbH Raffineriestr. 8 EU declaration of conformity...
Need help?
Do you have a question about the HT-ExVENT and is the answer not in the manual?
Questions and answers