Table of Contents
Advertisement
Lighting sequence
The lights used to illuminate your kettle are LEDs. The amount of energy used by LEDs is
very small—a fraction of the energy used by a normal light bulb.
Kettle
Kettle plugged in, kettle on/off switch OFF
Kettle plugged in, kettle on/off switch ON
Stand-by illumination
Your Breville filter kettle is fitted with Spectra stand-by illumination that lights the kettle
body with everchanging mood lighting. The Spectra stand-by illumination will go out after
approximately 20 minutes.
To restart the Spectra stand-by illumination do one of the following:
•
lift the kettle off the power base and replace it again
•
switch off the power supply socket and then switch it back on again
•
boil the kettle as normal
To switch off the Spectra stand-by illumination, simply turn the power supply off at the wall
socket or remove the plug.
The kettle does not need to have water inside whilst in the Spectra stand-by illumination
mode. However, please ensure that the kettle is filled with water, as per the instructions in
this book, prior to boiling.
Illumination
The Spectra stand-by illumination is active.
The water chamber softly glows through
the colour spectrum. The Spectra stand-by
illumination will go out after approximately
20 mins.
The water chamber illuminates and
changes from blue to red (assuming
that the water is cool) to indicate the
progress of the boiling cycle. The redder
the illumination, the closer the water is to
boiling. The on/off switch illuminates blue
during the boiling process.
lighting
7
Advertisement
Table of Contents
