Table of Contents
Advertisement
preparing the BRITA
1. Remove the cartridge from its wrapping (it is normal
for the cartridge to appear moist during storage).
2. Immerse the cartridge in cold water and shake gently
to remove any air bubbles. There is no need to pre-
soak this cartridge before use.
3. Insert the cartridge into the filter funnel and push it
firmly into place. When correctly fitted, the cartridge
should remain in place when the funnel is turned
upside-down.
4. Fill the filter funnel with cold tap water and allow it
to filter through, then discard the water. Repeat this
process, again discarding the water.
5. Refill the filter funnel with water - the BRITA
MAXTRA
cartridge is now ready for use. You do not
®
need to keep the filter cartridge immersed in water.
•
Always make sure that you have MAXTRA
cartridges to hand. When buying new cartridges
look for the BRITA
packaging.
•
When it is time to replace the BRITA
cartridge after 4 weeks use, simply lift the handle
on top of the cartridge and pull upwards to remove.
BRITA
cartridges are 100% recyclable. Visit www.
®
brita.co.uk or call the BRITA
information on participating retailers.
•
Repeat steps 1-5 with a new cartridge.
MAXTRA
filter on the cartridge
®
®
MAXTRA
®
Care team for further
®
MAXTRA
®
®
spare
®
filter
®
cartridge
®
5
Advertisement
Table of Contents
