Electronic Ignition; Support Leg Assembly; To Turn Off; To Store - Coleman GolfCat 5036A850 Instructions For Use Manual

To Light
cont

Electronic Ignition

Turn valve to HI
position and push the red
IGNITOR BUTTON until
heater ignites (10-12
seconds).
Heater will ignite with a
brief visible flame.
Heater is adjustable to "HI" and "LOW".
Note: If unit fails to light, check that you have
a fresh battery. You may also use the match
light procedure below:
Match Light
Hold match as shown.
Turn valve to HI
position.
Heater will ignite with a
brief visible flame after
10-12 seconds.
Heater is adjustable to
"HI" and "LOW".
NOTE: Heater is
designed to be lit with
the valve fully open until
it reaches full output.
Observe heat build up
for a few minutes to
ensure heater is lit. If
heater fails to develop
substantial heat, turn
heater "OFF" and repeat
lighting procedure.

Support Leg Assembly

Support Leg
A wire Support Leg is supplied with your unit as
an alternate means to support your heater.
Insert the wire Support Leg into the receiver holes
provided on each side of the heater head. Make sure
the support is fully inserted. The short wire studs
should rest against the metal heater head.
Before lighting, place the heater with Support Leg
on a flat and stable surface.
CAUTION
Cup Holder Adapter
• When using the
Support Leg Assembly,
DO NOT leave the Cup
Holder Adapter on the
heater.

To Turn Off

Turn FUEL VALVE to
OFF.
Allow HEATER to
cool for 10-15 minutes.

To Store

DANGER
• EXPLOSION - FIRE HAZARD
•
Never store propane near high heat, open flames,
pilot lights, direct sunlight, other ignition sources or
where temperatures exceed 120 degrees F (49°C).
5