Electronic Ignition; Match Light; To Turn Off; To Store - Coleman SportCat 5035A750 Instructions For Use Manual

To Light
cont

Electronic Ignition

■ Hold heater with both
hands at a 45° angle,
pointing away from
yourself and others.
■ Turn valve to ON
position and repeatedly
push red ignition button
until heater ignites.
■ Heater will ignite with a
brief visible flame after
10-12 seconds.
■ Place Heater on a flat
surface.
■ Heater is not adjustable.

Match Light

■ Hold match as shown.
■ Turn valve to ON
position.
■ Heater will ignite with a
brief visible flame after 10-
12 seconds.
■ Heater is not adjustable.
■ NOTE: Observe heat
build up for a few minutes
to ensure heater is lit. If
heater fails to develop
substantial heat, turn
heater "OFF" and repeat
lighting procedure.

To Turn Off

■ Turn FUEL VALVE to
OFF.
■ Allow HEATER to cool
for 10-15 minutes.

To Store

DANGER
• EXPLOSION - FIRE HAZARD
•
Never store propane near high heat, open flames,
pilot lights, direct sunlight, other ignition sources or
where temperatures exceed 120 degrees F (49°C).
To Store
cont
■ Make sure Heater is cool.
■ Take unit outdoors away from
any ignition sources. Remove
Cylinder from Heater.
■ Replace plastic cap on
cylinder.
■ Store propane cylinder
consistent with the instructions
and warnings on the cylinder.
Things You Should Know
1. This is a catalytic heater. Burning occurs within
the pad at a lower temperature than a normal
flame due to evenly distributed platinum. But, heat
guard and burner rim still get hot enough to burn
you. Be careful.
2. The catalytic process takes approximately 10
minutes to reach full heat output.
3. Do not use heater for cooking or warming items,
this can destroy combustion and catalyst. This
heater has a low burn temperature (no flame) but it
can still burn clothing, sleeping bags, etc., that
might fall on the burner surface.
4. To avoid damage to the catalyst, do not allow
head pad to come in contact with or around
silicone based hand creams, paints, etc.
5. Do not touch the gray ceramic fiber head pad or
poke a hole into it.
6. Do not attempt cleaning the head assembly.
5