Zanussi ZDT16017FA User Manual page 25

With some problems, the display shows
an alarm code:
•
- The appliance does not fill with water.
•
- The appliance does not drain the wa-
ter.
Problem
The programme does not
start.
The appliance does not fill
with water.
The appliance does not
drain the water.
After the checks are completed, activate the
appliance. The programme continues from the
point of interruption.
If the problem occurs again, contact the Serv-
ice.
If the display shows other alarm codes, con-
tact the Service.
If the washing and drying results are not
satisfactory
Whitish streaks or bluish layers on
glasses and dishes
• The released quantity of rinse aid is too
much. Adjust the rinse aid selector to a low-
er position.
• The quantity of detergent is too much.
www.zanussi.com
Possible cause
The mains plug is not connected in
the mains socket.
The appliance door is open.
The fuse in the fuse box is damaged.
The delay start is set.
The water tap is closed.
The water pressure is too low.
The water tap is clogged or there is
limescale on it.
The filter in the water inlet hose is
clogged.
The water inlet hose has a kink or a
bend.
The anti-flood device is on. There are
water leakages in the appliance.
The sink spigot is clogged.
The water drain hose has a kink or a
bend.
•
- The anti-flood device is on.
Warning! Deactivate the appliance
before you do the checks.
Connect the mains plug.
Close the appliance door.
Replace the fuse.
Cancel the delay start or wait for the
end of the countdown.
Open the water tap.
Contact your local water authority.
Clean the water tap.
Clean the filter.
Make sure that the position of the
hose is correct.
Close the water tap and contact the
Service.
Clean the sink spigot.
Make sure that the position of the
hose is correct.
Stains and dry water drops on glasses
and dishes
• The released quantity of rinse aid is not suf-
ficient. Adjust the rinse aid selector to a
higher position.
• The quality of the detergent can be the
cause.
Dishes are wet
• The programme is without a drying phase or
with a low temperature drying phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
• The quality of the combi detergent tablets
can be the cause. Try a different brand or
activate the rinse aid dispenser and use
Possible solution
25