Behmor 1600 Plus Cheat Sheet

Behmor 1600 Plus
Please read the factory included manual first, this is a
simplified sheet to get you started on your roasting journey.
BEFORE connecting the mains supply:
1. Clean the roast chamber:
Clean the interior of the roasting chamber with a soft cloth.
Check for any remnant packing material.
2. Set the supply voltage:
With the roaster unplugged, hold down the appropriate weight
button:
for 220 volt,
for 230 volt,
for 240 volt,
then connect the supply. The display will show the set voltage.
Press Start to permanently save the voltage setting.
(You won't need to do this again unless your supply voltage changes)
3.
Perform a dry burn (first time):
Without putting beans in the roaster,
press then
entire cycle, which will take a total of 22 minutes - 12 minutes of
heating followed by 10 minutes of cooling will count down in the
display. Press
un29, un28...) else the roaster will display Err7 and cooling will
commence earlier than it should.
– Cheat Sheet
. Allow the roaster to run through the
during the unattended countdown (un30,