Exhaust System - Echo SRM - 211SB Operator's Manual

3. Use the brush to remove dirt form cylinder fins.
IMPORTANT
Do not use a metal scraper to remove dirt from the cylinder fins.
4. Remove grass and leaves from the grid between the recoil starter and
fuel tank.
5. Assemble components in reverse order.

EXHAUST SYSTEM

Spark Arrestor Screen
Level 2.
Tools required: Cross head screwdriver, 3 mm hex wrench, soft
metal brush
Parts Required: Screen P/N 14586240630, Gasket P/N V104000360
1. Remove spark plug lead from spark pulg.
2. Remove engine cover. See "Cooling System Cleaning" for step by
step instructions.
3. Place piston at Top Dead Center (TDC) to prevent carbon/dirt from
entering cylinder.
4. Remove spark arrestor screen cover (A), gasket (B), and screen (C)
from muffler body.
5. Clean carbon deposits from muffler components.
NOTE
When cleaning carbon deposits, be careful not to damage the
catalytic body.
6. Replace screen if it is cracked, plugged or has holes burned through.
7. Assemble components in reverse order.
G T
RASS RIMMER
O
PERATOR
/B C
RUSH UTTER
' M
S ANUAL
C
B
A
23