Advertisement
Technical data
Viewing area (㎜)
Filter insert size (㎜)
Headband settings (㎜)
Material
Protection levels (adjustable on helmet)
Reaction time light/dark (s)
Reaction time dark/light (s)
Operating temperature (℃)
Optical class
Light diffusion
Light transmission variation (homogeneity)
Angular dependence of light transmission
Darkening rate
Operation
Adjusting the headband
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
93 × 42
110 × 90 × 9
ca. 90–120 (depth)
ca. 140 × 170–220 (width)
PP (flame-retardant)
9/10/11/12/13/grinding level
⁄
1
10,000
0.1–0.8
-10–+65
1
1
1
2
DIN 9-13 continuously adjustable on the exterior
1. Adjust the diameter of the headband with the knob on the back. The
knob is locked until pushed in. After unlocking, turn the knob clockwise to
tighten the headgear and anticlockwise to loosen the headgear.
2. Adjust the height by snapping the pin into the hole to secure it in place.
3. To adjust the angle of vision, loosen the knob on each side of the helmet
and adjust the angle screw to the desired tilt position (5 steps as standard
and positioned in the centre). Once the desired angle is reached, tighten
the knobs until they are snug. The helmet should still flip up but not slide
down when used for welding.
4. To adjust the distance between the user's face and the ADF, loosen the
knobs on both sides of the helmet until the headband moves freely back
and forth and position the headband as desired in one of the 3 slots (the
headband is positioned in the centre by default). This should be done one
after the other and both sides should be in the same position to ensure
proper functioning of the self-darkening filter.
Item 62600, 62602
Page 4
06 2021-1
Advertisement
