E N G L IS H CAREFULLY READ THE INSTRUCTIONS CONTAINED IN THIS MANUAL SINCE THEY PROVIDE IMPORTANT INFORMATION RELATIVE TO SAFETY DURING INSTALLATION, USE, AND MAINTENANCE. THIS APPLIANCE SHOULD BE INSTALLED BY APPROVED TECHNICAL SERVICE PERSONNEL. INTRODUCTION Thank you for choosing SCL - SC Ice Maker. You have purchased one of the most reliable ice-making products on the market today.
E N G L IS H 2. Overview Read this service manual carefully before installation, debugging and operation of this ice machine. This Service Manual gives an introduction of operation conditions, performance parameters, installation and debugging and operating procedures of SCL - SC ice machines. The ice machine system is of vertical, internal ice scraping type.
E N G L IS H SPECIFICATIONS SCL 400 - SC4 00 / SCL 600 - SC 600 MODEL PRODUCTION 0,4T 0,6T REFRIGERANT R449A POWER 1425W 2350W 25 o C AMBIENT TEMPERATURE 16 o C WATER TEMPERATURE WATER CONSUMPTION 17 L/H...
Page 10
E N G L IS H SCL 1T - SC 1TN / SCL 2T - SC 2TN / SCL 3T - SC 3TN Pipe connection diagram and installation measurement and size of ice outlet of 1-3-ton ice-maker. PIPE CONNECTION PIPE CONNECTION DIMENSIONS OF ICE OUTLE MODEL Ø...
Page 11
Pipe connection diagram and installation measurement and size of ice outlet of 5-ton and above ice-maker. PIPE CONNECTION PIPE CONNECTION DIMENSIONS OF ICE OUTLE MODEL Ø SCL 5T - SC 5TN 1850 1150 1000±1 1050±1 1100 SCL 10T - SC10TN 1850 1150 1000±1...
E N G L IS H DELIVERY AND UNPACKING Upon receipt, thoroughly inspect the packing container. If there appears to be damage to the container contact the shipper immediately. Unpack unit in the presence of delivery personnel noting any damage on the waybill. ITV packing bears the “Green Point”...
E N G L IS H 2. Installation procedure The ice-maker shall be lifted using the four shackles fixed on its base plate (for small-sized machine) or on its top (for large-sized machine) and shall be laid down slowly on the support or ice storage bin that has been put in place. For large-sized ice-maker, the correct steel cable lifting is as shown in this figure.
E N G L IS H 3. Stop When the “Start/Stop” button is switched off, water pump and solenoid valve stop working immediately, and the gear box stops working too after a 3-minute delay so as to remove the ice left on the interior of the vaporization cylinder. Now the pneumatic switch shall not be turned off before being delayed for 3 minutes.
E N G L IS H TROUBLESHOOTING Fault Description Possible Causes Recommendations Machine inactive Knob selector need to be Main switch is set to OFF position set to ON position (1) Power indicator not on Connection wire get loosened Check the wiring Clean or replace ice level control Malfunction of ice level control assembly assembly...