Contents; Safety Information - AquaScape EXT 12000 Instructions & Maintenance

Contents

No. Description
1. EXT Pond Pump

Safety Information

WARNING: To provide continued protection
against risk of electric shock, connect to
properly grounded, ground fault circuit
interrupter (GFCI) outlets only, using the
following guidelines:
(A) Have a qualifi ed electrician install a properly
grounded receptacle outlet, acceptable for outdoor
use and protected from snow and rain.
(B) Inspect cord before using.
(C) Do not use an extension cord.
(D) To reduce risk of electrical shock, all wiring and
junction connections should be made per local
codes. Requirements may vary depending on usage
and location.
(E) The power cable should be protected at all times to
avoid punctures, cuts, bruises and abrasions.
(F) Never handle power cords with wet hands.
(G) Do not allow the motor to become submerged.
(H) Never run dry. Never reverse rotation. Never exceed
an internal case pressure of: 100 PSI.
(I) Do not wear loose clothing that may become
entangled in the impeller or other moving parts.
(J) Keep clear of suction and discharge openings.
DO NOT insert fi ngers into pump with power
connected.
aquascapeinc.com | CAN (866) 766-3426 |
1
(K) Do not pump hazardous materials or liquids, such
as oil, saltwater or organic solvents.
(L) Do not block or restrict discharge.
(M) Products returned must be cleaned, sanitized, or
decontaminated, as necessary, prior to shipment to
ensure that employees will not be exposed to health
hazards in handling said material. All applicable laws
and regulations shall apply.
IMPORTANT: Aquascape, Inc. is not
responsible for losses, injury, or death
resulting from a failure to observe these safety
precautions, misuse or abuse of pumps or
equipment.
WARNING: Do not run dry
WARNING: Always shut off electrical power
before installation and/or servicing this pump.
All electrical wiring should meet state and local
ordinances. Improper wiring may not only be a
safety hazard but may permanently damage the motor
and/or pump. Current motors are only available for 60Hz
operation.
US (866) 877-6637
3