Operation; Starting Status (Power Switch On Mode); Operating Guide; Menu Operation - Black Box PG-VGA Manual

4. Operation

4.1 Starting Status (Power Switch On Mode)

1. To start the pattern generator, press the power on/off key for 2-3 seconds. It will
sound a long beep. The part number and the firmware version will display.
2. Press a function key (found below the LCD display). The PG-VGA will sound a
short beep confirming your selection.
3. The factory-preset starting value is P01 640x480 @60, where:
P01=Pattern 01
640x480=Resolution 640x480
@60=Refresh rate 60 Hz

4.2 Operating Guide

4.2.1 Menu Operation

To start operation, press the function key (located below "menu" on the LCD
display) to act ivate the menu.
724-746-5500 | blackbox.com
P01 640x480 @60
H/V MENU
Figure 4-1. Starting status screen.
P01 640x480 @60
H/V MENU
Figure 4-2. Menu.
Chapter 4: Operation
Page 9