Installation; Read These Notes First; Using The Pattern Generator - Black Box PG-VGA Manual

Pattern Generator—VGA

3. Installation

3.1 Read These Notes First

NOTES:
1. Before using the Pattern Generator—VGA (PG-VGA) for the first time, charge it
for more than 16 continuous hours.
2. If there is no image while using the PG-VGA, make sure that:
a. The battery is charged. If the battery is dead or faulty, the PG-VGA will not
switch on.
b. The resolution is bright enough. If the PG-VGA switches on but there is no
image, lower the resolution or change the resolution and vertical frequency.
Make sure the Sync mode is set to H/V or SOG and supports the monitor.
3. Charge the battery when the battery power indicator is low.
4. The PG-VGA will save the most recent setting automatically.

3.2 Using the Pattern Generator

Follow these steps to use the Pattern Generator:
1. Insert the external AC adapter into an AC outlet and connect the power cord to
the power jack on the PG-VGA unit.
2. Switch off the video display.
3. Connect the HD15 extension cord between the PG-VGA and the video display.
4. Switch on the video display.
5. Press the PG-VGA's power key for more than three seconds to switch the unit
on/off.
Page 8
724-746-5500 | blackbox.com