Installing The Ocp Card - Gigabyte H261-Z60 User Manual

3-9

Installing the OCP Card

• Voltages can be present within the server whenever an AC power source is connected.
This voltage is present even when the main power switch is in the off position. Ensure
that the system is powered-down and all power sources have been disconnected from the
server prior to installing a OCP card.
Failure to observe these warnings could result in personal injury or damage to equipment.
• Before installing the OCP card the left PCI-E riser assembly must be first removed, see
the Installing the PCI Expansion Card section for instructions on removing the PCI-E
riser assembly.
Follow these instructions to install the OCP card:
1. Install the OCP card bracket.
2. Secure the OCP card bracket with a screw.
3. Align the OCP card to the connector on the system board and push in the direction of the arrow
until the OCP card sits firmly in the system.
4. Secure the OCP card with three screws.
4
1
2
4
4
3
- 41 - System Hardware Installation