Highway/City Mode; Ultrabright Data Display Brightness - Cobra XRS 9300 Operating Instructions Manual

Settings
Your Detector
Settings
When changing the Settings on your detector, please keep in mind:
Buttons can have multiple functions.
All settings will be stored in memory when the power is
turned Off and recalled when the power is turned back On.

Highway/City Mode

Setting your detector to City mode delays all X band audio alerts until
the signal strength reaches Level 3. (A single beep will sound when the
signal is first detected.) This will reduce false alerts while you are driving
in, or near, urban areas where there are many sources for conflicting
X band signals such as microwave towers and automatic door openers.
To change settings, follow the procedure listed below, which indicates
what you will see and hear as you complete each step. The factory setting
is Highway mode.
Highway Mode
h
X K Ka V S
City Mode
c
X K Ka V S
City Button
Press and release
To Change From Highway Mode To City Mode
Press and release
Tone
the City button.
One (1) beep
To Change From City Mode back To Highway Mode
Press and release
Tone
the City button again.
Two (2) beeps
English
6
•
Visual Display
appears in the display
c
Visual Display
h
appears in the display
Settings
Your Detector

UltraBright Data Display Brightness

You can choose from three (3) settings for Brightness of the display.
You can cycle through the settings by repeatedly pushing the Dim button.
The factory setting is Bright.
Bright
Press and
release Dim
Dark
button
Dim
Dim Button
Press and
release
To Change The Brightness To Dim
Press and release
Tone
the Dim button
One (1) beep
once.
To Change The Brightness To Dark
Press and release
Tone
the Dim button
One (1) beep
again.
To Change The Brightness To Bright
Press and release
Tone
the Dim button a
Two (2) beeps
third time.
Visual Display
Display dims
Visual Display
Display remains dim
(no visual alerts will be seen)
Visual Display
Display returns
to full brightness
Nothing comes close to a Cobra ® 7