Porta-Dock 100A Instructions Manual

12/19/07
Page 1 of 7
U:\Judy\INSTRUCTIONS CURRENT\INSTR LIFTS\LIFT INST 1284-12113 CANTILEVER.doc
PORTA-DOCK, INC.
100A 1200 LB. 84" WIDE ALUMINUM CANTILEVER BOAT LIFT
102A 1200 LB. 113" WIDE ALUMINUM CANTILEVER BOAT LIFT
Thank you for purchasing our product!
Please read these instructions and follow them step by step. *
STEP 1. Separate and group like parts and fasteners together. Locate the four leveling legs with
pads (REF. # 1) and the two side members (REF. # 2 & 3) slide the four leveling legs into the
end upright tubes of the side members. Secure in place with 1/2" x 1" set screws REF. # 37) Set
the side members approximately 84" apart for 84" wide lifts and 113" apart for 113" wide lifts.
Make sure the rear gusset plate is to the outside and the small flat tabs on the bottom side tube
are to the inside.
STEP 2. Find the two bottom cross bar tubes
(REF. # 4) (They're the ones with the end
plates and channels welded on.) With the
channel facing to the rear of the lift set them
between the two side members so that the end
plate is up against the end of the tabs that are
welded on the bottom side tube. Fasten to
bottom tube with the eight square U bolts and
flange nuts. (REF. # 16 & 17) Finger
tighten nuts. Using a tape measure, square
the four corners of the uprights so that it is
within about a 1/4" Tighten all U-bolt nuts.
5 - 43