Download Print this page

Sealey LED3601 Series Instructions page 2

Rechargeable 360 lithium - polymer inspection lamp 2w cob + 1w led

Advertisement

2. introduction
mini, lightweight lamp with exclusive patented design owned and registered to sealey. unique and innovative 360° swivel and tilt function
enables the light source to be positioned in any direction. featuring a super bright 2W coB led light source, which gives an even and
constant spread of light. Produces up to 180 lumens with a cri-80 rating. recessed lens for added protection. 1W High power led located
in top of the lamp for directional torch use, produces up to 90 lumens. rubber covered magnet in base and swivel hook for hands-free
operation. Hook doubles as pocket/belt clip for easy carrying when not in use. High quality rechargeable 3.7V 1.5Ah li-polymer battery for
longer life, no memory effect and a much slower discharge than traditional ni-mH batteries. micro usB charging port. supplied with mains
charger and usB cable.
3. specification
model no's: .................. led3601b, led3601g, led3601r
Battery: .................................................. li-Poly 3.7V - 1.5Ah
led quantity: ........................................................1 + 1xcoB
lumen output top/side: ............................................ 90/180lm
cri rating side: .................................................................. 80
operating time top/side: .................................................6/3hr
charging time: ...................................................................3hr
minimum length: ......................................................... 160mm
maximum length: ........................................................ 170mm
important WArrAntY informAtion
V
the battery fitted to this cordless tool is considered to be a consumable item and its ability to accept a charge will reduce over time.
We will warranty it against mechanical and electrical defect for a period of one year - this does not cover fair wear and tear. if the
battery is not properly charged before first use, or regularly conditioned, its capacity will diminish. Under these circumstances we
will not replace the battery even if it is less than one year old.
note: fully charge the battery before first use.
note: the lithium battery does not suffer from memory effect and once fully charged may be stored for up to six months without
another charge.
4. operation
Refer to fig.1
4.1.
connect the charger into the charge socket on back of the lamp. Plug into power supply and turn on, the charging led on the lamp
will light red to show charging has commenced.
4.2.
When the battery has fully charged the led will turn Green.
4.3.
direct the lens away from your eyes before switching on.
4.4.
toggle the lamp between 1W end and 2W coB using the push switch.
4.5.
suspend the lamp by the hanging hook. When the light is hanging from the hook it can be rotated through 360° for more precise
positioning.
4.6.
Alternatively use the magnet on the base to attach the lamp to any ferrous surface.
© Jack sealey limited
Original Language Version
fig.1
led3601 series| issue 2(sP) 27/08/15

Advertisement

loading

This manual is also suitable for:

Led3601bLed3601gLed3601r