Advertisement
3. USING THE DISPENSERS
3.1 Remove either the upper or lower paper bar from the frame by unscrewing and
removing the wing bolts at either end.
3.2 On one side of the bar loosen the screws of the black paper holding rings and
remove the rings, spring and washers from the end of the bar. Remove the card
board tube centre of the last roll from the bar.
3.3 Slide the the paper bar through the centre of the new paper roll and refit the
washers, spring and rings to the end of the bar. Temporarily tighten the screws in the
holding ring.
3.4 To refit the loaded bar to the frame get a second person or persons to support the
paper roll while the wing bolts are fitted at either end of the bar. The paper should be
coming off the top of the roll. Once loaded, check that the roll is centrally placed on
the paper bar and make any necessary adjustments using the black holding rings.
3.5 Push a roll of masking tape onto each tape dispensing reel and spin it to make sure
the tape is running true. Check that the tape dispensers are aligned with the ends
of the paper roll as shown in Fig.3. (The centre line of the tape should align with the
edges of the paper roll.) The position of the tape dispensers can also be adjusted as
shown in Fig.2. To increase or decrease dimension 'X' loosen the wing nut 'Z' and
wing nut 'Y' up or down the bolt as required. Retighten the wing nut.
3.6 Pull about 450mm of paper from the roll and feed it between the paper spring and the
back edge of the adjacent cutting blade.
3.7 Pull tape from each dispenser in turn and stick it to the paper roll so that it is half on and half off the paper edges. Check the alignment of the
tapes and make any further adjustments required to the positions of the tape dispensers.
3.8 Slowly pull the paper from the roll and check that the tapes feed correctly onto the edges of the paper.
3.9 Tear the paper off with an upward movement against the down facing teeth of the paper blade. Keep hands well away from the blade when
doing this.
3.10 Load the other paper bar as described above.
NOTE: A fully loaded frame is quite heavy. Take care when moving it and always leave it in a stable position.
Fig.3
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our catalogue and latest promotions call us on 01284 757525 and leave your full name, address and postcode.
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
01284 757500
www.sealey.co.uk
Web
01284 703534
sales@sealey.co.uk
email
MK66.V3 Issue: 1 - 08/10/09
Fig.2
Advertisement
