Package Contents; Part Ii. Installation; Hardware Installation; Software Installation - SCM Microsystems Microtech CameraMate CompactFlash Quick-Start Installation And Operating Instructions

Package Contents

• CameraMate™ Reader/Writer (CompactFlash™ or SmartMedia™) with attached 1
meter Parallel cable
• CD-ROM with Driver Installer and Bonus Software
• This User's Guide
• Registration Card

Part II. Installation

Hardware Installation

Begin by unpacking your CameraMate™ from its carton. ALWAYS turn off your
computer's power before connecting the CameraMate™. If a printer is connected to the
system, remove the printer and follow the procedures as described below.
1) Align and connect the 25-pin male connector (attached to the CameraMate™) firmly
to the computer's LPT1 parallel port (printer port).
2) Tighten the screws on the side of the connector.
3) Remove the keyboard plug from the PS/2 keyboard port located on the back of the
computer and plug it into the female receptacle (PS/2 pass-through) attached to the
CameraMate™.
4) Insert the male (PS/2) plug attached to the CameraMate™ into the keyboard (PS/2)
port located on your computer.
5) If necessary, reconnect your printer to the printer pass-through connection on the
CameraMate™.

Software Installation

Start your Windows™ 95/98/2000/Me operating system as described below and follow
the on-screen instructions to install the appropriate driver software. Skipping steps may
cause improper operation.
Note: Please confirm that the hardware installation was properly completed before
installing the software. If you need to make changes, turn off the computer first before
disconnecting any devices.
3