Advertisement
FIELD PROGRAMMING INSTRUCTIONS
These instructions may be used to enter, change or verify the following
1051 SERPENTINE LANE, STE. 400
Phone (925) 485-9490
INTELLIMETER
INTRODUCTION
• CT CONSTANT
• SYSTEM NUMBER
• GROUP NUMBER
• UNIT NUMBER
• FIBER OPTIC CABLE INSTALLATION
• PHASES
• WATT READING
Document A-7004-22 Rev. -
December 22, 1998
osc /I
NTELLIMETER
1
®
PLEASANTON, CA 94566
Fax (925) 485-9537
A-7004-22 Rev. -
Advertisement
Table of Contents
Related Manuals for OSC Intellimeter Series
Summary of Contents for OSC Intellimeter Series
- Page 1 • UNIT NUMBER • FIBER OPTIC CABLE INSTALLATION • PHASES • WATT READING Document A-7004-22 Rev. - December 22, 1998 osc /I NTELLIMETER PLEASANTON, CA 94566 1051 SERPENTINE LANE, STE. 400 Fax (925) 485-9537 Phone (925) 485-9490 A-7004-22 Rev. -...
- Page 2 Intellimeter Field Programming Instructions To program the Intellimeter, attach a battery operated terminal or PC with terminal emulation (i.e. communications) software to the Intellimeter at the programming port using the appropriate cable supplied from the factory. Configure the terminal or PC for 600 Baud, No Parity, 8 Data Bits, 1 Stop Bit, XON/XOFF, Full Duplex Program the Intellimeter, following the steps below.
- Page 3 Press <Ctrl> + Q (PRV) verify the “2 REPEATER” is displayed. Press <Ctrl> + E (SAV) to save option setting. Press < = > (equal symbol). Verify that SYSTEM #, GROUP #, and UNIT # have been entered correctly. Option should display "2" if a 600 Baud Fiber-Optic Link is to be used, "0" if not.
Need help?
Do you have a question about the Intellimeter Series and is the answer not in the manual?
Questions and answers