X-RIDER Honda RC213V-S Manual page 6

【Ready To Run Preparation / 跑前准备工作】
Step1. Check all the parts in the box. 检查包装里的部件
When you open the box, you will find follow parts 打开包装盒，有以下部件：
Motorcycle Transmitter
摩托车
发射机
1set 1set
Equipment Sold Separately: 以下配件客户需要单独购买：
Silicone Oil, Screw Glue, Tire Rubber 润滑油，螺丝胶，轮胎胶 。
Tool Required 以下工具在操作中有可能会使用到：
Hex screwdriver,Cross Wrench,Cross Screwdrive,Tweezers,Hex Wrench.
内六角螺丝刀，车用小十字扳手，十字螺丝刀，镊子，内六角扳手
Step 2. Remove the R-Clip and the body shell 将车壳和车尾壳底部的R扣拆下并取出上下壳
Step 3. Connect the battery with the ESC. 连接电池与电子调速器的接线
Caustion: When connect the battery with the ESC, please keep the ESC in off state.
注意：电池连接电调前，请保持电调处于关闭状态。
Step 4. Install anti-roll bars ,body shell and helmet. 安装摩托车的防倾杆、外壳和头盔。
1) Install the aniti-roll bar and put it set into the aniti-roll bar post then lock each of the grains.
将防倾杆安装到车架的插孔位置，并用机米将每个插孔锁紧。
2) Install the helment on the body shell, then install the boday shell on the main frame,fix the body shell
post with the R-clip.先将头盔安装在车壳上，再将整个车壳安装在车架上，车壳柱穿过车壳并用R扣固定。
Battery Charge Anti-roll Bars
充电器 防倾杆组
1pc 1set
USB Flash Disk Bike Stand
固定架
U盘
1pc 1pc