Mazak VTC-200B Operating Manual page 521

Return to Library
Alarm No.
Alarm Name
(SQ Coil No.)
283 NOT UNCLAMPED
(F83) (NOT STOP SPINDLE)
284 NOT UNCLAMPED
(F84) (SPDL ORI. UNFIN)
285 NOT UNCLAMPED
(F85) (NOT MANUAL MODE)
286 NOT AUTO MODE
(F86) (UNCLAMPED TOOL)
287 NOT AUTO MODE
(F87) (MAG. MANUAL OPER)
289 NO TOOL LOAD
(F89) (ARM/SFTER POS
ERR)
290 NO TOOL LOAD
(F90) (MAGAZINE POS ERR)
291 NO TOOL UNLOAD
(F91) (TOOL IN MAG.)
292 NO UNLOAD
(F92) (ARM/SHIFTER POS
ERR)
293 NO TOOL UNLOAD
(F93) (MAG. POS ERROR)
294 NO TOOL SELECT
(F94) (INCORRECT TNo.)
295 NO TOOL SELECT
(F95) (ARM/SFT POS ERR)
296 NO TOOLCHANGE
(F96) (AXIS NOT ATC POS)
302 ATC ARM DRIVER
(F102) MALF.
303 ATC ARM 0ﾟ MALF.
(F103)
310 CAN'T ATC COVER
(F110) CLOSE
313 MMS SKIP SIGNAL
(F113) MALF.
314 PTP ERROR
(F114)
Description
The TOOL UNCLAMP button is pressed
while the [SPDL JOG] menu key is held
pressed or while the spindle rotating.
The TOOL UNCLAMP button is pressed
although the spindle orientation has not
been completed.
The TOOL UNCLAMP button is pressed in
other than the manual mode.
An attempt is made to change the operation
mode to automatic while the tool is
unclamped.
An attempt is made to change the operation
mode to automatic while manually setting or
removing a tool at the magazine.
The tool load command is executed
although the ATC arm is not in the correct
position.
The tool load command is executed
although the magazine is not in the correct
position.
The tool unloading command is executed
although a tool exists at the tool change
position in the magazine.
The tool unload command is executed
although the ATC arm is not in the stand-by
position.
The tool unload command is executed
although the magazine is not in the
specified position.
A tool number greater than the magazine
capacity is specified or No. 0 is specified
although No. 0 pocket does not exist in the
magazine.
The magazine rotation command is
executed although the ATC arm is not in the
stand-by position.
The tool change command is executed
although the axis is not in the ATC position.
Alarm with the ATC arm controller
The 0° completion signal is not turned on
although the ATC arm 0° command is
executed.
The ATC cover close command is executed
although the ATC arm is not in the stand-by
position.
The touch sensor skip signal is turned on
when the axis movement is in the rapid
traverse.
The fixed point positioning is specified in
either ATC, pallet change or tool length
measurement, but the fixed point positioning
completion signal is not turned on even after
10 minutes passed.
2-5
Sensor Detecting
Machine Status
the Alarm
Tool unclamp is disabled. Y300
Tool unclamp is disabled. Y2D6
X246
Tool unclamp is disabled
Mode switching is disabled. SQ11, X91,
SQ10, X90,
SA1, X10C
Mode switching is disabled. SA4
X16
Attempted operation is
disabled.
Attempted operation is
disabled.
Attempted operation is
disabled.
Attempted operation is
disabled.
ATC arm stops. ATC arm
controller
Attempted operation is ATC arm
disabled. controller
Attempted operation is
disabled.
Emergency stop