Advertisement
STEP 7. Turn the cabinet upside down and
screw in the four adjustable leg levellers (R).
Bolt the four corner braces (I) into position
using 16 bolts (O), 16 lock washers (P), and 16
nuts (Q)
STEP 10. Attach a left hand female slide (K) to
left hand side of each draw and a right hand
female slide (K) to the right hand side of each
draw (see diagram 11). Engage each draw onto
the protruding male slides and push fully home,
then open the draw to check that it is retained.
Sole UK Distributor, Sealey Group,
Bury St. Edmunds, Suffolk.
STEP 8. Place the wooden top (N) face down
on a flat, clean, smooth surface. Place the
cabinet upside down on the wooden top and
align it with the four pre-drilled holes. Fix with
the four hex head screws (S).
Diagram 11. Orientate each slide as shown in the diagram above with the rear hook pointing
towards the rear of the draw or the rear of the cabinet. Put the rear hook on each slide into the
square hole nearest the back of the draw or the back of the cabinet and push the slide backwards
to engage the hook. Swivel the front of the slide up or down slightly until the other two hooks appear
in the other two holes. Keep the rear face of the slide up against the draw or slide panel. On the
draws pull the slide sharply upwards to engage it. On the cabinet push the slides down to engage.
01284 757500
STEP 9. Take the 10 male slide components
(M) and slide 5 onto the female slides on the
left of the draw compartment and 5 onto the
female slides on the right hand side of the draw
compartment. Push them fully in to engage
them, then pull them out to the stop point.
01284 703534
E-mail: sales@sealey.co.uk
AP2030 - 2 - 120702
Advertisement
