Zte MC801A Getting Started page 12

SIGNAL
1.
(Three lights)
2. NETWORK
3. WIFI
4. POWER
5.
WPS key
External antenna
6.
port
7. PHONE port
8. LAN ports
9.
Power port
nano-SIM card
10.
slot and reset
hole
On: Three lights show the signal strength. More lights on means
better signals.
Off: There is no signal or no nano-SIM card inserted.
Red: The device is powered on but not registered to the mobile
network.
Blue solid: The device is registered or connected to the 3G/4G mobile
network.
White solid: The device is registered or connected to the 5G network.
On: WLAN(Wi-Fi) works normally.
Blinking: WPS is activating.
Off: WLAN(Wi-Fi) is off.
On: The device is powered on.
Off: The device is powered off.
Press this key to activate the WPS function.
Connect to external antennas. The antenna connector type is TS-9
and antenna frequency range is from 700 MHz to 4200 MHz.
This port is not active and cannot be used.
LAN1 port: Connect to the WAN in the Cable Broadband Mode.
LAN2 port: Connect to a PC.
Connect to the power adapter.
Insert your nano-SIM card.
Reset hole: Press and hold for about 3 seconds to restore your
device to the factory settings.
11