Fazzini F-205 Instructions For Use Manual page 28

Questo apparecchio soddisfa I requisiti della norma IEC 60601-1-2.
The equipment meets the requirements of IEC 60601-1-2.
Questo apparecchio ha bisogno di particolari precauzioni e deve essere installato e messo in servizio in base alle informazioni EMC
fornite di seguito. Apparecchiature di comunicazione RF portatili e mobili possono influenzare questo dispositivo. Vedere le tabelle
C-1, C-2, C-3 e C-4
The equipment needs special precautions regarding EMC and needs to be installed and put into service according to the EMC
information provided below. Portable and mobile RF communications equipment can affect this device. See tables C-1, C-2, C-3 and C- 4
NOTA – Non aprire o modificare i contatti dell'apparecchio, le operazioni su questo apparecchio devono essere fatte esclusivamente
da personale autorizzato dal fabbricante
NOTE - Do not open or modify the contacts, the operations of this unit shall be made only by authorized personnel from the
manufacturer
ATTENZIONE
WARNING
Table C-1
The equipment are intended for use in the electromagnetic environment specified below. The customer or the user of the equipment should
assure that they are used in such an environment.
Emissions Test
RF Emissions CISPR 11
RF Emissions CISPR 11
Harmonic Emissions IEC 61000-3-2
Voltage, Fluctuations/Flicker Emissions, IEC 61000-3-3 Not applicable
Table C-2
The equipment is intended for use in the electromagnetic environment specified below. The customer or the user of the equipment should
assure that it is used in such an environment.
Immunity test
Electrostatic Discharge (ESD) IEC 61000-4-2
Fast transient IEC 61000-4-4
Surge IEC 61000-4-5
Voltage dips,Short interruptions and voltage
variation on power supply input lines
IEC 61000-4-11
Power Frequency (50/60 HZ)
Magnetic Field IEC 61000-4-8
F-205_Rev.3_25.01.2017
COMPATIBILITÀ ELETTROMAGNETICA
EMC
ELECTROMAGNETIC COMPATIBILITY
Questo simbolo identifica i connettori che non devono essere toccati e/o collegati senza istruzioni precise. Tutto
il personale che utilizza questo apparecchio deve essere istruito sul significato di questo simbolo
This symbol identifies the connectors that must not be touched and/or connected without precise instructions. All
persons using this equipment must be instructed on the meaning of this symbol
Guidance and manufacturer's declaration - electromagnetic emissions
Group 1
Class A
Not applicable
Guidance and manufacturer's declaration - electromagnetic emissions
IEC 60601
Test level
±6 kV contact
±8 kV air
Not applicable, the equipment is powered by internal battery.
3 A/m
Compliance
The equipment uses RF energy only for its internal function.
Therefore, its RF emissions are very low and are not likely to
cause any interference in nearby electronic equipment.
The equipment is suitable for use in all establishments, other
than domestic and those directly connected to the public low-
voltage power supply network that supplies buildings used for
domestic purposes.
Compliance
level
Floors should be wood, concrete or ceramic tile. If floors
±6 kV contact
are covered with synthetic material, the relative humidity
±8 kV air
should be at least 30%.
Power frequency magnetic fields should be at levels
3 A/m characteristic of a typical location in a typical commercial
or hospital environment.
F-205
Electromagnetic environment - guidance
Electromagnetic environment — guidance
.:: 28 / 31 ::.