Triminator TRP Series Quick Start Manual

QUICK START GUIDE
TRIMINATOR TRP SERIES ROSIN PRESSES
1

GETTING STARTED WITH YOUR PRESS

SET / ADJUST TEMP

CHECK CURRENT TEMPERATURE SETTING
1 Press the UP BUTTON and
the SET TEMP will show
2 Press the SET BUTTON and the
SET
CURRENT TEMP will show again

INCREASE TEMP

1 Press and hold the UP BUTTON
for 3 SECONDS
2 At desired temp, press the
SET
SET BUTTON

DECREASE TEMP

1
Hold the UP ARROW for
3 SECONDS
2 Then, press the DOWN ARROW
until the DESIRED TEMP is shown
3 Press the SET BUTTON
SET
WHY ARE THE
TEMPERATURES
FLUCTUATING?
WHY DIDN'T THE
TEMPERATURE
DECREASE AFTER I
LOWERED THE TEMP?
ARE THE PIDS
READY TO GO?
2
BETWEEN
160°F - 190°F
PLATTEN TEMPERATURE
190°F - 220°F
MAX RECOMMENDED 225°F
PLATTEN TEMPERATURE
thetriminator.com
STEPS TO HELP DIAL IN THE
TO BRING PRESS TO TEMP FASTER
on start up, press platens lightly together at
<500 PSI when bringing press to temperature
FAQ
The PIDs fluctuate while getting to and maintaining temperatures
to account for atmospheric changes and temperature influences on
the platens. Over time they learn the environment and fluctuate
less, there will always be some variation within a few degrees.
The platens are designed to hold heat, once you lower the temp in
the PID it takes some time for them to lose heat. After setting to a
lower temp, the current temp will be displayed on the PID, if the
platen is cooling the temp will drop over time to the set temp.
Yes. They come factory set. For advanced setting or to reset the
PIDs see "PID Troubleshooting" section in the owner's manual.

PICK A TEMP

TEMPERATURE TIPS

LOW TEMP / COLD PRESSING
BUDDER MAINTAIN MAXIMUM
LIKE
CONSISTENCY
HOT PRESSING
OIL,
SHATTER LIKE
CONSISTENCY
OWN YOUR HARVEST™
OUT
(AT)
SET
Rosin TRP PID
ALM
OUT
SET
Rosin TRP Stack PID
SOME SACRIFICE
IN YIELD
TERPENES
CON'S
PRO'S
INCREASE IN POTENTIAL DECREASE
YIELD
IN TERPENES
CON'S
PRO'S
530.265.4277