Advertisement
Quick Links
Installation & Operations Manual
VoIP Pool Phones
624POOLVOIP, 624MPOOLVOIP, 690SYPOOLVOIP,
690RDPOOLVOIP, 984RIP, 984RIPC1, 970VOIP,
2100-986DIP, 990SYPOOLVOIP, 990RDPOOLVOIP
RP8500VOIP
N56W24720 N. Corporate Circle
Sussex, WI 53089
Made in the USA
Ver. 3
800-451-1460
www.rathcommunications.com
3 Year Warranty
04/21
Advertisement
Related Manuals for Rath 624POOLVOIP
Summary of Contents for Rath 624POOLVOIP
- Page 1 Installation & Operations Manual VoIP Pool Phones 624POOLVOIP, 624MPOOLVOIP, 690SYPOOLVOIP, 690RDPOOLVOIP, 984RIP, 984RIPC1, 970VOIP, 2100-986DIP, 990SYPOOLVOIP, 990RDPOOLVOIP RP8500VOIP N56W24720 N. Corporate Circle Sussex, WI 53089 Made in the USA Ver. 3 800-451-1460 www.rathcommunications.com 3 Year Warranty 04/21...
-
Page 2: Table Of Contents
Thank you for purchasing a RATH VOIP Pool Phone. We are the largest Emergency Communication ® Manufacturer in North America and have been in business for over 35 years. We take great pride in our products, service, and support. Our Emergency Products are of the highest quality. -
Page 3: Mounting
Mounting 624POOLVOIP, 624MPOOLVOIP, 970VOIP Items Needed: • POE port on Network Switch • Drill • Drill bit or knockout set • Mounting screws • Conduit with water tight connector • 1/8” Allen wrench (provided) • Screwdriver • Mounting feet (provided) Installation: 1. - Page 4 690RDPOOLVOIP, 990RDPOOLVOIP, 690SYPOOLVOIP (YELLOW), 990SYPOOLVOIP (YELLOW) Items Needed: • POE port on Network Switch • Drill • Metal capable drill bit or knockout set • Mounting screws • Wall anchors • Conduit with water tight connector • 3/32” Allen wrench (provided) •...
-
Page 5: Programming
Programming Items Needed: 1. PC with Network Interface Card attached to same network as SIP Server 2. Static IP Address for IP Interface (provided by building) 3. IP Address of SIP Server or Web Address of ITSP (Internet Telephony Service Provider) (provided by building) 4. - Page 6 RESET Button: To reset all information entered into the IP Pool Phone, unplug the Ethernet cable from the Ethernet port on the IP interface board then press and hold the red reset button for 20 seconds. THIS WILL DEFAULT THE UNIT TO DHCP (you will no longer be able to log into the device using 192.168.1.160).
-
Page 7: Wiring
“DATA POWER IN” Adjusting the Volume Speaker Phones Volume Adjust VR1 Adjusting the Microphone: RATH SmartPhone ® If the person you are calling reports your voice is not loud enough, increase the Microphone Sensitivity by adjusting VR2 a 1/4 turn clockwise (requires a small Phillips screwdriver). -
Page 8: Troubleshooting
624POOLVOIP, 690SYPOOLVOIP, 690RDPOOLVOIP 1. Open door on unit and remove 4 screws securing the red internal plate. Lift the plate out and flip it over to expose the keypad. 2. Above and slightly underneath the keypad will be a small dipswitch labeled “ON”...