Related Manuals for Rath 2100 Series
Summary of Contents for Rath 2100 Series
- Page 1 Installation & Operations Manual 2100 Series Wi-Fi VoIP Phone N56W24720 N. Corporate Circle Sussex, WI 53089 RP8500WIFISIP 800-451-1460 www.rathcommunications.com Made in the USA Ver. 3 3 Year Warranty 07/18...
- Page 2 Thank you for purchasing RATH’s Wi-Fi VoIP Phone. We are the largest Emergency Phone Manufacturer in North America and have been in business for over 35 years. We take great pride in our products, service, and support. Our Emergency Phones are of the highest quality.
- Page 3 Items Needed • Static IP addresses (1 for VoIP Phone, 1 for Wireless Module) • IP address of SIP Server and Authentication ID • PC with Network Interface Card • 120v or 12v battery backed up power source (not needed for 9’ Towers, 5’ 8” Pedestals, or 36” Call Stations) Note: If you provided the IP information at the time of purchase, all devices will be labeled with the IP information used to log into the devices.
- Page 4 VoIP Phone Set-Up 1. Connect the Ethernet port of the VoIP Interface to the PC using an ethernet cable 2. Change computer IP address a. Navigate to Control Panel b. Navigate to Network Settings c. Change the IP address of the PC to 192.168.1.150 3.
- Page 5 Phone Programming On-Site Programming: Step 1. To Begin Program Mode a. Press Enter Step 2. To Program Emergency Numbers a. Press 1, Enter, (phone number), Stop Note: To program numbers 2-5, repeat step 2A Step 3. To Program Location Message a.
-
Page 6: Adjusting The Volume
Adjusting the Volume If the volume is too low or high, adjust it by referring to the diagram and instructions below. Rath SmartPhone Volume Adjust VR1 Mic Sensitivity VR2 Adjusting the Microphone: If the person you are calling reports your voice is not loud enough, increase the Microphone Sensitivity by adjusting VR2 a 1/4 turn clockwise (requires a small Phillips screwdriver).
Need help?
Do you have a question about the 2100 Series and is the answer not in the manual?
Questions and answers