Advertisement
Table of Contents
Operator: Save these instructions for future use!
FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY
BEFORE INSTALLING OR OPERATING THIS CONTROL COULD CAUSE
PERSONAL INJURY AND/OR PROPERTY DAMAGE.
This adaptor plate assembly is designed for mounting a
Comfort-Set 70 series thermostat to the wall or to a
junction box. The wall cover plate covers the junction box,
wall damage, or old thermostat markings. The adaptor
plate is designed to allow horizontal thermostat mounting,
regardless of junction box orientation.
All kits may not have adaptor plate or all screws shown.
CAUTION
!
To prevent electrical shock and/or equip-
ment damage, disconnect electrical power
at main fuse or circuit breaker until installa-
tion is complete.
CONTENTS
Description ........................................................ 1
Precautions ....................................................... 1
Installation ......................................................... 2
White-Rodgers is a division
of Emerson Electric Co.
www.white-rodgers.com
F61 Series
Adaptor Plate Assembly
INSTALLATION INSTRUCTIONS
F61-2510
Wall Plate
NOTE
This instruction sheet is not intended as a wiring guide.
Refer to the thermostat installation instructions to ensure
proper wiring.
Printed in U.S.A.
DESCRIPTION
Adaptor Plate
No. 6 X 5 / 16 " Phillips
pan-head screw (2)
6-32 X 3 / 4 " flat-head
machine screw (4)
PRECAUTIONS
PART NO. 37-6408A
0223
Advertisement
Table of Contents
Related Manuals for White Rodgers F61 Series
Summary of Contents for White Rodgers F61 Series
- Page 1 F61 Series Adaptor Plate Assembly INSTALLATION INSTRUCTIONS Operator: Save these instructions for future use! FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING OR OPERATING THIS CONTROL COULD CAUSE PERSONAL INJURY AND/OR PROPERTY DAMAGE. DESCRIPTION This adaptor plate assembly is designed for mounting a Comfort-Set 70 series thermostat to the wall or to a junction box.
- Page 2 INSTALLATION FOR 1F7X DIGITAL THERMOSTATS 3 / 4 6-32 X ” flat-head machine screws Junction Box No. 6 X 5 / 16 ” Phillips pan-head screw (2) F61-2510 Wall Plate Subbase 1F7X Thermostat Figure 1. Mounting 1F7X digital thermostat to horizontal junction box. Locate and drill two clearance holes in wall 6-32 X...
- Page 3 NOTE When installing wall cover plate and thermostat directly to wall, use the pointed screws supplied with the thermostat. No. 6 X 1” pan-head screws (supplied with thermostat) No. 6 X 5 / 16 ” Phillips Wall pan-head screw (2) F61-2510 Wall Plate Subbase...
- Page 4 For additional product information, please visit www.white-rodgers.com The Emerson Logo is a trademark and a service mark of Emerson Electric Co.
Need help?
Do you have a question about the F61 Series and is the answer not in the manual?
Questions and answers