Download Print this page
On-Q/Legrand IC5004 Series Instruction/Installation Sheet

On-Q/Legrand IC5004 Series Instruction/Installation Sheet

Selective call intercom patio unit

Advertisement

Quick Links

301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
1. Introduction
The On-Q /Legrand Selective Call Intercom Patio Unit, PN IC5004-XX
(see Figure 1), is weather resistant for outdoor use, and supports
responding to a selective call, initiating a page within the house, local
control of the mute and monitor functions and the ability to talk to a Door
Unit. A separate high quality speaker and microphone provide superior
sound quality. It is available in white (-WH), shiny brass (-SB), antique
brass (-AB), brushed stainless (-BS) and oil-rubbed bronze (-OB).
2. Description
The Patio Unit is a 2-gang product that mounts within an outdoor
weatherproof box (56" from the floor to the bottom of the box). There is
also a two-gang surface-mount box available (P/N IC5006-BK) for unique
or retrofit installation requirements.
3. Installation
Installation of the Selective Call Patio Unit is best accomplished at multiple times during new construction, at
"Rough-in" before the drywall is installed, and at "Trim-out" after the drywall is installed and painted.
A. "Rough-in" steps:
1. Run a Cat 5 cable from the Enclosure where the Selective Call Intercom Module will be installed to the
2 gang box at the Selective Call Patio Unit location.
NOTE: A single Patio Unit in a one Module system may be run up to 1000 feet from the Module to
support a remote application. All other Patio Units on the system must be within 330 feet (100 meters)
of the Distribution Module.
NOTE: It is important to keep all Category 5e cable runs, regardless of use, at least 12 inches away from
AC electrical cables. If it proves necessary to cross an existing AC cable, do so only at a 90 degree
angle.
B. "Trim-out" steps:
NOTE: All terminations can be correctly completed by following the T568A pin assignments. It is
important that you accurately terminate using T568A at all locations. All terminations of the Selective Call
Intercom System are RJ45 jacks. Refer to Figure 2 for correct T568A termination of RJ45 plugs.
Figure 2
©Copyright 2008 by On-Q/Legrand All Rights
INSTRUCTION/INSTALLATION SHEET
Selective Call Intercom Patio Unit
RJ-45
RJ-45
.
Reserved
Pin
Pin
1 – White/Green
1 – White/Green
2 – Green
2 – Green
3 – White Orange
3 – White Orange
4 – Blue
4 – Blue
5 – White/Blue
5 – White/Blue
6 – Orange
6 – Orange
7 – White/Brown
7 – White/Brown
8 – Brown
8 – Brown
IS-0388 REV. A
Figure 1
Page 1 of 3

Advertisement

loading

Summary of Contents for On-Q/Legrand IC5004 Series

  • Page 1 4 – Blue 4 – Blue 5 – White/Blue 5 – White/Blue 6 – Orange 6 – Orange 7 – White/Brown 7 – White/Brown 8 – Brown 8 – Brown Page 1 of 3 Reserved ©Copyright 2008 by On-Q/Legrand All Rights...
  • Page 2 Selective Call Intercom Module and verify system functionality. All Selective Call Room, Door and Patio Units will be discovered and shown on each Room Unit LCD. RJ45 jack set screws Figure 4 Page 2 of 3 Reserved ©Copyright 2008 by On-Q/Legrand All Rights...
  • Page 3 While in MUTE mode, both the speaker and microphone of the unit will be inactive. MUTE mode is useful for maintaining privacy in a particular living space. Page 3 of 3 Reserved ©Copyright 2008 by On-Q/Legrand All Rights...

This manual is also suitable for:

Ic5004-wh372926