Advertisement
5. Installation
As shown in the picture below, turn the tub over, wrap the tub hole with PTFE
1.
tape and then screw in the siphon.
2.
Turn the bathtub around. Move the bathtub to the right place in your bathroom;
put the siphon in the drain and seal it. Adjust the feet of the bath so that the
bath is horizontal and level.
3. Carry out the electrical installation, connecting the bathtub with cables of at
least 2.5 mm2 to a socket that has a 16A magnetothermic, 30mA differential
and earthing.
Advertisement
