Advertisement
5. After all tanks on your vessel have been set up, press
to return to the main display.
Boat Setup Reset
If you want to access the Setup screen (Boat Setup) after an engine-
tank configuration has been chosen you will have to reset the configu-
ration to default settings.
To reset engine-tank configuration:
1. Press
, highlight
MENU
2. Choose
E
/T
NG
will appear: Press ENTER to reset Eng/Tnk Cfg.
3. Press
MENU
lighted.
EP-80R TH Configuration
The EP-80R TH Temperature sensor has three configuration options:
Inside, Outisde and Water. An unconfigured temperature sensor will
appear on the bus devices list as UnCfg Temp.
To configure a temp sensor:
1. Press
, use the
MENU
press
.
ENTER
2. Highlight
B
US
pear.
3. Select an unconfigured temp sensor (
The following message will appear: Press Enter to Configure Temp Sen-
sor.
4. Press
ENTER
tions: Water Temp, Outside Temp and Inside Temp.
5. Highlight the desired option and press
figured. You will be directed to the Bus Devices list. Press
edly to get back to the main display.
NOTE:
If your temp sensor is not updated on the Bus Devices list, refresh
the list by closing it and then access it again.
To unconfigure a temp sensor:
1. Press
, use the
MENU
press
.
ENTER
2. Highlight
B
US
pear, showing all devices detected on the network.
Busse-Yachtshop.de
S
YSTEM
and press
C
ANK
FG
. The Setup Menu will appear with Boat Setup high-
and
UP
and press
D
EVICES
, which will open the Select Temp menu with three op-
and
UP
and press
D
EVICES
and press
S
ETUP
twice. The following message
ENTER
keys to select
DOWN
. The Bus Devices list will ap-
ENTER
U
C
N
FG
ENTER
keys to select
DOWN
. The Bus Devices list will ap-
ENTER
16
info@busse-yachtshop.de
repeatedly
EXIT
.
ENTER
S
S
YSTEM
) and press
T
EMP
. The temp is now con-
EXIT
S
S
YSTEM
and
ETUP
.
ENTER
repeat-
and
ETUP
Advertisement
