Navigation Settings - Clarion EZD580 Owner's Manual

Button
Auto Time Correction to GPS Use this feature to synchronise the clock of your device to the very
Use Auto Time Zone
Set Time Zone
Compare GPS and device
times

4.5.5 Navigation settings

You can control how Clarion EZ Drive behaves during navigation. Tap the following buttons:
,
Button
Keep Position on Road
Off-route Recalculation
Restore Lock-to-Position
Automatic Overview
62
accurate time provided by the GPS receiver.
Use this feature to synchronise the time zone of the clock of your
device to the time zone based on your current GPS position. This is
useful if you travel abroad.
Set time zone manually if you do not want to synchronise the time
zone automatically. This allows you to use Auto Time Correction and
apply a time zone offset to obtain the desired time.
The current time of the GPS receiver and the device clock are
displayed. Please note that the GPS clock is only available with GPS
reception. This allows you to check whether any correction is needed.
.
This feature allows car drivers to always correct GPS position errors
by matching the vehicle position to the road network. For pedestrian
navigation, this feature is automatically disabled to let the software
show your exact position.
By turning off this feature you also turn off the GPS position error
filtering. The position shown on the map will be subject to all position
errors and position fluctuations.
This switch tells Clarion EZ Drive whether to automatically recalculate
the route when you deviate from it. If this feature is turned off, you
need to initiate route recalculation otherwise navigation will be stopped
until you return to the originally recommended route.
Setting another point than the current GPS position as the start point
of the active route will automatically disable this feature.
If you have accidentally moved the map during navigation, this feature
can move the map back to your current GPS position after the given
period of inactivity.
This feature will switch the map view to Overview mode when the next
route event is at a distance. Overview is a zoomed out 2D view to let
you see the surrounding area. You have the following controls for
Automatic Overview:
•
Turn Distance for Overview: The map view will be switched to
Overview mode if the next route even is at least as far as this
value.
•
Default Zoom Level: Overview mode will appear with this zoom
level. You can scale the map in Overview mode but next time
Overview appears again, this zoom level will be applied.
Description
Description
,