Configuration - Abbott CONNECT Setup Manual

Setup Guide: CONNECT Universal Gateway With ID NOW
Abbott Rapid Diagnostics Informatics, Inc. (ARDx Informatics)

Configuration

In order for the second ID NOW
configuration steps are required, as follows:
Step Action
1 VERIFY that the second ID NOW
on.
TURN ON the CONNECT Universal Gateway.
Note: The CONNECT Universal Gateway will
automatically switch on once attached to power. If
this does not occur, press the Power button.
2 CHECK the status lights on the CONNECT
Universal Gateway

Observe and check the three device status
lights 1, 2 and 3.

If a solid Status 1 light does not appear within
two minutes, restart the CONNECT Universal
Gateway by pressing and holding down the
Power button for five seconds.

The Status 2 light will flash while the device
attempts to connect.

The Status 3 light will remain solid green
when a successful connection is established
with RALS LiNK
3 POWER ON the second ID NOW device.
Ssubsequent steps will be completed on the second
TM
ID NOW device.
D10036883 REV AA
All trademarks referenced are trademarks of either the Abbott group of companies, or their respective owners.
TM
instrument to communicate with the CONNECT Universal Gateway, additional
TM
device is powered
TM TM
or Sympheos .
Page 16 of 26
© 2021 Abbott. All rights reserved.
Any photographs displayed are for illustrative purposes only.
TM
(Direct-Connect)
Illustration
February 1, 2021