Download Print this page

Epson ET-2600 Start Here

Hide thumbs Also See for ET-2600:

Advertisement

Quick Links

ET-2600
Start Here
Read these instructions before using your product.
Note for Spanish speakers/Nota para hispanohablantes:
obtener instrucciones de configuración en español, consulte la Guía
de instalación en www.epson.com/support/et2600sp (requiere una
conexión a Internet).
1
Unpack
Note:
Do not open the ink bottles until you are ready to fill the ink
tanks. The ink bottles are vacuum packed to maintain reliability. Ink
bottle design may vary.
1
Remove all protective materials from the product.
2
Lift up the scanner unit and remove all protective materials
from inside the product.
Caution:
Do not touch the flat white cable or the ink tubes and
their translucent cover.
3
Lower the scanner unit.
Para
2
Fill ink tanks
Note:
This product requires careful handling of ink. Wear disposable
gloves and place a sheet of paper or plastic under the ink tank when
you fill or refill the ink tanks, as ink may splatter. If ink spills, wipe it off
immediately with a damp towel to avoid permanent stains. If ink gets on
your clothes or belongings, it may not come off.
Warning:
Keep the ink bottles out of the reach of children and do not
drink the ink.
1
Open the ink tank cover, then remove the cap for the black
ink tank and attach it to its holder.
2
Unpack the black ink bottle.
3
Depending on the ink bottle included with your product,
snap off the bottle tip or unscrew the lid.
4
Remove the bottle cap. Carefully remove the protective
seal (avoid touching the ink underneath the seal), then
close the bottle cap tightly.
Caution:
Be sure to close the bottle cap tightly, or ink may leak.

Advertisement

loading

Summary of Contents for Epson ET-2600

  • Page 1 Read these instructions before using your product. Note for Spanish speakers/Nota para hispanohablantes: Para obtener instrucciones de configuración en español, consulte la Guía de instalación en www.epson.com/support/et2600sp (requiere una conexión a Internet). Fill ink tanks Note: This product requires careful handling of ink. Wear disposable...
  • Page 2 Raise the control panel and turn on the product. Wait for Fill the tank using all of the ink in the bottle. power light to stop flashing, then follow step 12 to continue ink charging. Note: Refer to the color coded sticker on the ink tank to identify the color of each tank.
  • Page 3 Cancel and disconnect the USB cable. Make sure the product is on and securely connected as shown: nsert the product CD or download and run your product’s software package: www.epson.com/support/et2600 (U.S.) or www.epson.ca/support/et2600 (Canada) Follow the instructions on the screen to run the setup program.
  • Page 4 Mac is a trademark of Apple Inc., registered in the U.S. and other countries. General Notice: Other product names used herein are for identification purposes only and may be trademarks of their respective owners. Epson disclaims any and all rights in those marks. This information is subject to change without notice.