AEG FAVORIT45002WO User Manual page 27

7.2 Setting and starting a
programme
Setting mode
The appliance must be in setting
mode to:
• Start a programme.
• Set the level of the water soft-
ener.
• Activate the rinse aid dispens-
er when the Multitab function
is on.
Turn the programme knob until the pro-
gramme marker is aligned with a pro-
gramme on the control panel:
• If the programme duration flashes in
the display, the appliance is in setting
mode.
• If the programme duration in the dis-
play is not flashing, the appliance is
not in setting mode.
To put the appliance in setting mode,
press and hold Multitab and Delay until
the programme duration flashes in the
display and the phase indicators for the
programme come on.
Starting a programme without
delay start
1. Open the water tap.
2. Close the appliance door.
3. Turn the programme knob until the
programme marker is aligned with
the programme you want to set.
Make sure that the appliance is in
setting mode.
• The programme duration flashes in
the display.
• The phase indicators of the set
programme come on.
4. Press Start. The programme starts.
• The programme duration stops
flashing in the display and starts to
decrease with steps of 1 minute.
• Only the indicator of the phase in
operation stays on.
Starting a programme with
delay start
1. Set the programme.
2. Press Delay again and again until the
display shows the delay time you
want to set (from 1 to 19 hours).
• The delay time flashes in the dis-
play.
3. Press Start. The countdown starts.
• The delay time stops flashing in
the display. The countdown starts
to decrease with steps of 1 hour.
• The phase indicators of the set
programme go off.
• When the countdown is completed,
the programme starts.
– The indicator of the phase in opera-
tion comes on.
Opening the door while the
appliance operates
If you open the door, the appliance
stops. When you close the door, the ap-
pliance continues from the point of inter-
ruption.
Cancelling the delay start
while the countdown operates
Press Delay again and again until the
display shows the programme duration
and the phase indicators of the set pro-
gramme come on. The programme
starts.
Cancelling the programme
Press and hold Multitab and Delay until
the programme duration flashes in the
display and the phase indicators of the
set programme come on.
Make sure that there is detergent
in the detergent dispenser be-
fore you start a new programme.
At the end of the programme
When the programme is completed, the
display shows 0 and the phase indicators
go off.
1. Deactivate the appliance. Turn the
programme knob until the pro-
ENGLISH
27