Advertisement
CONTENTS
A. BEFORE USING..........................................................................................2
B. SETTING THE TIME AND CALENDAR......................................................3
C. FUNCTIONS OF SOLAR POWERED WATCH ..........................................6
Insufficient Charge Warning Function..........................................................7
Quick Start Function ....................................................................................7
Overcharge Prevention Function .................................................................7
D. CARE AND HANDLING DURING CHARGING ..........................................8
E. ABOUT THE RECHARGEABLE CELL ......................................................9
F. TIME REQUIRED FOR CHARGING .........................................................10
G. IN THESE CASES .....................................................................................12
H. PRECAUTIONS.........................................................................................14
I. SPECIFICATIONS.....................................................................................20
1
Advertisement
Table of Contents
Related Manuals for Citizen Eco-Drive 200 Meter BM6400-00E
Summary of Contents for Citizen Eco-Drive 200 Meter BM6400-00E
-
Page 1: Table Of Contents
CONTENTS A. BEFORE USING...2 B. SETTING THE TIME AND CALENDAR...3 C. FUNCTIONS OF SOLAR POWERED WATCH ...6 Insufficient Charge Warning Function...7 Quick Start Function ...7 Overcharge Prevention Function ...7 D. CARE AND HANDLING DURING CHARGING ...8 E. ABOUT THE RECHARGEABLE CELL ...9 F. -
Page 2: Before Using
This watch is not powered by a conventional battery, but is powered by converting light to electrical energy. Before using, be sure to fully charge your watch by exposing it to light. (See “F. TIME REQUIRED FOR CHARGING”, for charge time reference) Once fully charged, the watch will continue to run for approximately 6 months without additional charging. -
Page 3: Setting The Time And Calendar
B. SETTING THE TIME AND CALENDAR [1] Three-hand models without calendar display * If your watch has a screw-type crown, lift up the crown to loosen it before operation. Be sure to press the crown down firmly after operation. Solar cell... - Page 4 [2] Models with calendar (date and weekday) display * If your watch has a screw-type crown, lift up the crown to loosen it before operation. Be sure to press the crown down firmly after operation. [Date display models] Solar cell...
- Page 5 1. Stop the second hand by pulling the crown out to the 2nd click (time setting position). 2. Turn the crown to set the time. 3. The watch will start after the crown is firmly pushed back into its normal position. Setting the calendar 1.
-
Page 6: Functions Of Solar Powered Watch
One second interval movement When the watch is exposed to light, the Quick Start Function will begin operating and the second hand will start moving. The correct time can be set once the watch is fully charged. If insufficient charge continues... -
Page 7: Insufficient Charge Warning Function
Insufficient Charge Warning Function The second hand changes to a two second interval movement to indicate insufficient recharging. Even in such a case, the watch keeps correct time, but about 4 days after the two second interval movement begins, the watch will stop. -
Page 8: Care And Handling During Charging
Please note that if you wear long sleeves, your watch may be hidden from light and may result in insufficient charging. As such, additional exposure to light may be necessary. • When you take your watch off, be sure to place it in as bright an area as possible. Notes on recharging •... -
Page 9: About The Rechargeable Cell
CAUTION: The rechargeable cell should last the life of the watch. Never allow anyone other than an Authorized Service Center to replace this cell. The movement is designed to operate with only the original rechargeable cell. If an alternate cell is installed,... -
Page 10: Time Required For Charging
F. TIME REQUIRED FOR CHARGING Time required for recharging may vary according to the design of the watch (color of the dial, etc) and operating environment. The following table will serve as an approximate reference: (Table of recharging) Illuminance Environment... - Page 11 CAUTION: When recharging the watch after it is completely in the stop state, be sure to pull out the crown to the time setting position. After recharging, set the time and push the crown firmly back into its normal...
-
Page 12: In These Cases
1 week. (Insufficient Charge Warning Function) In such a case, expose your watch to light for a while to cancel the warning. (The second hand returns to moving at one second intervals when the energy is recharged.) - Page 13 [If the watch warns you to set the time.] When the watch that has stopped is exposed to light, the second hand starts hitch movement. (Quick Start Function) The time elapsed before the second hand starts moving depends on the illuminance of the light.
-
Page 14: Precautions
H. PRECAUTIONS CAUTION: Water-resistance performance There are several types of water-resistant watches, as shown in the following table. Indication Dial WATER RESIST or No indication RESIST(ANT) WATER RESIST(ANT) WR50 or WATER RESIST 50 WATER RESIST(ANT) WR100/200 or WATER RESIST(ANT) WATER RESIST 100/200 WATER RESIST(ANT) The unit “bar”... - Page 15 For correct use within the design limits of the watch, confirm the level of water- resistance of your watch, as indicated on the dial and case, and consult the table. Examples of use Moderate exposure to water (washing, Marine sports (skin...
- Page 16 • If moisture has entered the watch, or if the inside of the crystal is fogged up and does not become clear within a day, immediately take the watch to your dealer or Citizen Service Center for repair. Leaving the watch in such a state will allow corrosion to form inside.
- Page 17 • If seawater enters the watch, place the watch in a box or plastic bag and immediately take it in for repair. Otherwise, pressure inside the watch will increase, and parts (crystal, crown, buttons, etc.) may come off. CAUTION: Keep your watch clean.
- Page 18 Doing so may result in a skin burn. • Do NOT leave the watch in a place where it is exposed to high temperature, such as the glove compartment or dash-board of a car. Doing so may result in deterioration of the watch, such as deformation of plastic parts.
- Page 19 • Do NOT subject the watch to a strong shock such as dropping it onto a hard floor. • Avoid using the watch in an environment where it may be exposed to chemicals or corrosive gases. If solvents, such as thinner and benzine, or substances containing such solvents come in contact with the watch, discoloration, melting, cracking, etc.
-
Page 20: Specifications
6. Display features: 7. Additional features: 8. Duration time: 9. Power Source: * Specifications are subject to change without prior notice. Analog solar powered watch Within ±15sec/month (within a normal temperature range of 5°C/41°F to 35°C/95°F) 32,768Hz C/MOS-LSI (1 pc.)