KLOP INNOVATIONS Aircleaner AC2 User Manual page 23

6.1.3 SELECTING THE
FILTER PACKAGE
��
Press to access the Settings. Press
again to see the selected filter package:
FILTERPACKAGE. Press
��
repeatedly pressing
that corresponds to the filter package
inserted in the machine. If the correct filter
package comes into view, confirm it by
pressing ��. If no new selection is made, the
menu can be exited by pressing
last filter package when
display. The originally selected filter package
will be retained.
6.1.4 TESTING FILTERS –
ACTIVATING THE
TEST MENU
��
Press to access the Settings. Press
again to see the selected filter package:
FILTERPACKAGE. And by pressing
the test menu for the filters can be activated:
FILTERTEST. Press ��. The
SINGLE
display shows the filter to be inserted. By
pressing several times ��, it is possible to
navigate between the filters to be tested.
6.1.5 FILTER TESTING –
START TEST
After inserting the filter, close the cover and
press ��. The fan will turn on and the status
of the placed filter will be shown on the
display by means of a bar that indicates the
flow: the more blocks in the display, the
higher the degree of saturation/clogging of
��
��
and navigate by
to the filter package
��
after the
EXIT
appears in the
��
��
again,
the tested filter. Repeat the above steps for
the other filters and replace the most
saturated filter first. After the last single
filter test, the message to reinsert all filters
appears on the display. Confirm with
return to the initial situation.
6.2 Switching on the
Aircleaner AC-2
• Place the Aircleaner AC-2 in the room
• Connect the power cord to a socket
��
• Press
Ù
For ERROR messages: see section 7
6.3 Switching off the
Aircleaner AC-2
��
• Press
• For complete disconnection, remove the
power cord from the socket
EN
��
to
23 23