Troubleshooting - TZS First AUSTRIA FA-5700-2 Instruction Manual

WORK LIGHT
If additional light is needed,press the light switch to turn the light' On'. Press the
switch again to turn it'Off'.
SEWING SLEEVES
This sewing machine has been designed to sew sleeves or any narrow
openings in garment .
1. Lift the presser foot.
2. Position the garment over the sewing arm.
3. Lower the presser foot and follow the regular sewing instructions.
DRAWER
On the side of the sewing machine (towards the rear) is a drawer for the handy
storage of accessories
BOBBIN WINDING
1. Put a spool of thread on spool pin (Fig.1).
2. Place the thread to the right of the bobbin winder tension disk (Fig. 2)
3. Push the bobbin into the bobbin winder pin and push it to the left. (Fig. 3)
4. Wind thread clockwise around bobbin several times.
5. Open the speed switch to start winding.(Fig. 4)
6. Stop winding after correct volume ofthread is winded on bobbin. (Fig. 5)
7. Take bobbin off the spindle and cut the thread.
FEATURES
ADJUSTING STITCHING
1. As shown in the picture (Fig. 1) normal stitching shall
be neat with top and bottom threading neither too tight nor
too loose.
2. If the bottom threading looks like a straight line, which
indicates the top thread is too loose. Please turn too tight
nor too loose clock wise to increase pressure until the
stitching returns to normal. (Fig. 2)
3. However, when the top thread looks like a straight line
indicating an over-tight top thread, slowly turn the upper
thread tension dial counterclockwise to reduce pressure until the stitching back to normal. (Fig. 3)
6
SEWING A BUTTONHOLE MANUALLY
1. Put the cloth under the presser foot and lower the presser foot on the cloth where you need to
sew buttonhole, then choose the stitch pattern #8.
2. Turn on the switch and sew 5-6 stitch in low speed, then turn off the switch (Fig. 1).
3. Choose the stitch pattern #7, turn on switch and sew on the cloth in suitable length, then turn off
switch. Note that try to keep sewed stitch in straight line (Fig. 2).
4. Choose thestitchpattern#8, then turn on switch and sew 5-6 stitch in low speed, then turn off
switch (Fig. 3).
5. Raise the presser foot, rotating the cloth for 180° ( Fig.4)
6. Choose the stitch pattern #7, then turn on switch and sew till buttonhole is fully sewed. (Fig. 5)

TROUBLESHOOTING

Problem Problem cause
No power or the Batteries are installed
machine runs slowly incorrectly
Batteries are low
Adaptor power inadequate
Skipping stitches Needle eye not in the middle
Needle bent
Presser foot too loose
Bobbin thread cannot Lower thread has been used up Replace with new full bobbin
be drawn up
Needle threaded incorrectly
Thread keeps breaking Needle bent
Needle shank not properly
seated
Thread tension dial, thread
guide or thread pulling bar too
tight
Stitches too loose or Thread blocked by upper
uneven bobbin
Upper thread too loose
Needle breaks Needle bent or deformed
Amendment
Reinstall the batteries making sure they
are the oorrect way around
Use new batteries
Use compatible adaptor
Remove and re-insert the needle with
the flat side of the needle to the back
Remove and re-insert a new needle
Tighten the presser foot
Re-thread the needle, making sure it is
threaded from the front to the back
Remove and re-insert a new needle
Remove and re-insert a new needle
Loosen the thread tension between 3-5
number
Pull out the spool pin and make the
bobbin or thread run smoothly
Remove and re-insert a new needle
7