Duramaxx 10028071 Manual page 11

• (A) Pull-up 4 clasps due to arrow's direction, making the clasps depart from the cover (B).
• Holding the barrel, grab at the outlet pulling upward, forcing the cover to separate from the barrel
(C).
• lf you don't use biochemical cotton, you can put any other fi lter media alternatively as you require.
After putting media, it should be the opposite direction as bottom fi lter plate (E).
• Then put on the cover again, press it fl atly to make it fi t the barrel, re-fasten the four buckles (F).
• Put one inlet and outlet to the bottom of the body, and put another inlet and outlet to the lid (G).
Fasten these two inlet and outlets.
• Doing this please make sure the 0-ring is at the correct position
• Please connect the inlet and outlet pipe when it is used for the fi rst time, forcibly suck the inlet pipe.
Let the inlet pipe and bucket are full of water by siphonage, then install other spare parts (see below).
Attention: the outlet pipe must be immersed in the water while absorbing water, and the bucket must
below the tank level. Another way, pour three-quarters water, put the cover and turn on the power. Bring
up the fi lter to the same levei of the tank to make it start work.
11
(F / G).