Starting The Engine - Yamaha T155 2021 Owner's Manual

Starting the engine

The starting circuit cut-off system will
enable starting when:
 the transmission is in the neutral
position or
 the transmission is in gear with the
clutch lever pulled.
To start the engine
1. Turn the main switch on and set
the engine stop switch to the run
position.
2. Confirm the indicator and warning
light(s) come on for a few sec-
onds, and the go off. (See page
4-3.)
TIP
Do not start the engine if the engine
trouble warning light remains on.
NOTICE
Do not continue to operate the vehi-
cle if a warning light remains on.
Have a Yamaha dealer check the ve-
hicle.
3. Shift the transmission into the
neutral position.
Operation and important riding points
4. Start the engine by pushing the
EAU54462
start switch.
5. Release the start switch when the
engine starts, or after 5 seconds.
Wait 10 seconds before pressing
the switch again to allow battery
voltage to restore.
NOTICE
For maximum engine life, never ac-
celerate hard when the engine is
cold!
ECA26710
TIP
This model is equipped with a lean an-
gle sensor to stop the engine in case of
a turnover. In this case, turn the main
switch off and then on. Failing to do so
ECA11043
will prevent the engine from starting
even though the engine will crank
when pushing the start switch.
6-2
EAU45312
6