Viro VEGA Quick Start Manual

Viro VEGA Quick Start Manual

Hide thumbs Also See for VEGA:

Advertisement

IMPORTANT: An ADULT must make all repairs. Thoroughly inspect all parts after making modi cations. DO NOT RIDE until
you are sure the proper repairs have been made and the unit is assembled according to the manufacturer's speci cations.
NOTE: BEFORE BEGINNING, ENSURE THE UNIT IS TURNED OFF.
1
With the unit in the scooter position, pull the lever on the back
of the seat and lift it up. Then, lift the seat latch out of the way.
A second person may be required to hold the seat up during
battery replacement.
3
Remove the plastic piece.
5
Carefully disconnect the batteries from the internal wiring by
pressing in the clasp on the connector and pulling apart.
If you are unsure of any repairs, contact consumer service.
2
Use a small screwdriver to remove the three
screws on the battery cover under the seat.
4
Remove the plastic battery cover.
6
Remove the batteries.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the VEGA and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Viro VEGA

  • Page 1 IMPORTANT: An ADULT must make all repairs. Thoroughly inspect all parts after making modi cations. DO NOT RIDE until you are sure the proper repairs have been made and the unit is assembled according to the manufacturer’s speci cations. If you are unsure of any repairs, contact consumer service. NOTE: BEFORE BEGINNING, ENSURE THE UNIT IS TURNED OFF.
  • Page 2 Place the fresh batteries in the unit. Place the fresh batteries in the unit. Connect the wiring to the clip inside the unit. Replace the battery cover and plastic piece. Replace all three screws and secure them tightly with a screwdriver. Turn the unit on to ensure the batteries are working Replace the seat latch and lower the deck.

Table of Contents