Cisco 3825 Non Proprietary Security Policy page 4

Cisco 3825 and Cisco 3845 Routers
Figure 3 Cisco 3825 Front Panel Physical Interfaces
The Cisco 3825 router features a console port, auxiliary port, dual Universal Serial Bus (USB) ports,
four high-speed WAN interface card (HWIC) slots, two 10/100/1000 Gigabit Ethernet RJ45 ports, two
Enhanced Network Module (ENM) slots, small form factor pluggable (SFP), redundant power supply
(RPS) inlet, power inlet, and Compact Flash (CF) drive. The Cisco 3825 router supports two internal
advanced integration modules (AIMs)
Figure 3
SYS PWR LED, RPS LED, AUX PWR LED, AIM0 LED, AIM1 LED, PVDM0 LED, PVDM1 LED,
PVDM2 LED, and PVDM3 LED. The back panel contains LEDs to indicate the status of the GE ports.
The front panel contains the following:
•
•
•
•
•
The rear panel contains the following:
•
•
•
•
•
•
Table 1
of the router:
1. However, an AIM module may not be installed in accordance with this security policy. There is a separate
security policy covering the Cisco 3825 and Cisco 3845 routers with AIM module installed.
Cisco 3825 and Cisco 3845 Integrated Services Routers FIPS 140-2 Non Proprietary Security Policy
4
1
shows the front panel. The front panel consists of 12 LEDs: CF LED, SYS LED, ACT LED,
LEDs
Power switch
Power input
CF drive
USB ports
HWIC/WIC/VIC slots 0 and 1
Console port
Auxiliary port
GE ports
ENM Ports
SFP Port
and Table 2 provide more detailed information conveyed by the LEDs on the front and rear panel
2 3
1
COMPACT FLASH
CF
0
DO NOT REMOVE DURING NETWORK OPERATION
1
, and two Ethernet connections.
4 5 6
100-240 V~ 3A
50/60 Hz
SYS AUX
SYS ACT PWR RPS PWR AIM0 AIM1 PVDM0 PVDM1 PVDM2 PVDM3
Figure 2 shows the rear panel and
OL-8662-01