PerfectVision PV5HEC-F Installation Manual

1
90°
3
3 - 4
ROTATIONS
4
Do not nick or cut through these wires
The two cutoff sections should both be 1/4" long.
5
NO
Inspect your work carefully before
attempting to install the connector.
Look for all of these issues:
PERFECT
Look closely at the innermost
aluminum foil shield to ensure it is
flat against the dielectric foam.
PV5HEC-F-Install_09132016_ALB_V4
Cut the end of
the cable cleanly
with sharp cutters
at a 90° angle.
Turn the prep tool three or four full and continuous revolutions
around the coax. Do not reverse the direction of the turn, it is
unnecessary and can damage the braid.
0.25"
• Conductor is straight
• Braid wires are pushed back
neatly and evenly
• Dielectric is round and smooth
U.S. Toll Free 1.866.470.0887
2
0.25"
It is important to make sure ALL the braid
wires are folded back neatly.
6
International +1.501.955.0032
©2016 PerfectVision Manufacturing
PV5HEC-F
Installation Guide
Insert the coax into the
appropriate cable prep tool
so the end of the coax is
flush against the stop.
Coax against
the stop
We recommend using the Ripley
brand LDT-MINI coax preparation
tool for best results.
Align core up with
connector post and
load cable into rear
F connector shell
www.perfect-vision.com